Fire Pump Test|42 Complete Q’s and
A’s
Heat exchangers shall be checked for _____ water flow. - -cooling
- All alarm pilot lights should be in what state? - -Off
- There are two requirements listed under pump house conditions, choose
both listed below. - -Ventilating louvers are free to operate & Heat is
adequate, not less than 40F for diesel pump rooms.
- Weekly inspection requires verification that pump suction discharge and
bypass valves should be fully open? - -True
- When verifying the electrical system conditions, the controller pilot light
should be? - -Green
- Diesel engine fuel tank level, float switch and solenoid valve operation
shall be checked _____. - -weekly
- What fire pump type do you record the time to crank? - -Diesel
- The pertinent visual observation categories required to be inspected
weekly checklist are? - -Pump house conditions, Pump system conditions,
electrical system conditions, diesel engine system conditions, steam system
conditions.
- The purpose of inspecting the pump assembly? - -Appears to be in
operating condition and is free from physical damage
- The transfer switch normal pilot light should be illuminated. - -True
- The isolating switch for electric pumps should be closed. - -True
- Pump packing boxes, bearings and casing shall be checked for _____. - -
overheating
- The reverse phase alarm pilot light for electric pumps should be off. - -
True
- The purpose of testing the pump assembly is to ensure automatic and
manual operation upon demand and continuous delivery of the required
system output. An additional purpose is to detect _____. - -deficiencies not
evident by inspection
A’s
Heat exchangers shall be checked for _____ water flow. - -cooling
- All alarm pilot lights should be in what state? - -Off
- There are two requirements listed under pump house conditions, choose
both listed below. - -Ventilating louvers are free to operate & Heat is
adequate, not less than 40F for diesel pump rooms.
- Weekly inspection requires verification that pump suction discharge and
bypass valves should be fully open? - -True
- When verifying the electrical system conditions, the controller pilot light
should be? - -Green
- Diesel engine fuel tank level, float switch and solenoid valve operation
shall be checked _____. - -weekly
- What fire pump type do you record the time to crank? - -Diesel
- The pertinent visual observation categories required to be inspected
weekly checklist are? - -Pump house conditions, Pump system conditions,
electrical system conditions, diesel engine system conditions, steam system
conditions.
- The purpose of inspecting the pump assembly? - -Appears to be in
operating condition and is free from physical damage
- The transfer switch normal pilot light should be illuminated. - -True
- The isolating switch for electric pumps should be closed. - -True
- Pump packing boxes, bearings and casing shall be checked for _____. - -
overheating
- The reverse phase alarm pilot light for electric pumps should be off. - -
True
- The purpose of testing the pump assembly is to ensure automatic and
manual operation upon demand and continuous delivery of the required
system output. An additional purpose is to detect _____. - -deficiencies not
evident by inspection
