ASE A3
Clutch slippage may be caused by which of the following?
a. Worn or rough clutch release bearing
b. Excessive input shaft end play
c. Leaking rear main seal
d. Weak or broken torsional springs - ANSWERS-c. Leaking rear main seal
A vehicle comes in with hard shifting concerns, particularly into first gear.
Technician A says the first speed blocking ring is the MOST likely cause. Technician
B says the clutch could be out of adjustment. Who is right? - ANSWERS-b. B only
If a transmission can be shifted into two gears at the same time, what is the MOST
likely cause? - ANSWERS-Faulty interlock
gold-colored particles in the fluid come from? - ANSWERS-Worn blocking rings
worn blocking rings in the fluid come from? - ANSWERS-Gear wear
A transaxle jumps out of gear under load. What is the most likely cause? -
ANSWERS-Shift linkage is maladjusted, worn or loose
, True or false? Vibration at high speed can be caused by an incorrect rear "U" joint
operating angle - ANSWERS-True
A squeaking noise in reverse is caused by... - ANSWERS-A worn cross shaft bearing
surface
A transfer case will not shift from the low gear ratio up to direct drive or 1:1 ratio.
Which of the following is the MOST likely cause?
a. Broken shift shaft spring
b. Faulty shift indicator
c. Damaged planetary gearset
d. Broken shift shaft - ANSWERS-d. Broken shift shaft
Noise: In gear, clutch disengaged (pedal to floor) - ANSWERS-Pilot bushing or
bearing
Noise: Neutral, clutch disengaged (pedal to floor) - ANSWERS-Release bearing
Noise: Neutral, clutch engaged (pedal up) - ANSWERS-Input shaft bearing
Binding U-Joint will damage?? - ANSWERS-Extension housing bushing and seal
Clutch slippage may be caused by which of the following?
a. Worn or rough clutch release bearing
b. Excessive input shaft end play
c. Leaking rear main seal
d. Weak or broken torsional springs - ANSWERS-c. Leaking rear main seal
A vehicle comes in with hard shifting concerns, particularly into first gear.
Technician A says the first speed blocking ring is the MOST likely cause. Technician
B says the clutch could be out of adjustment. Who is right? - ANSWERS-b. B only
If a transmission can be shifted into two gears at the same time, what is the MOST
likely cause? - ANSWERS-Faulty interlock
gold-colored particles in the fluid come from? - ANSWERS-Worn blocking rings
worn blocking rings in the fluid come from? - ANSWERS-Gear wear
A transaxle jumps out of gear under load. What is the most likely cause? -
ANSWERS-Shift linkage is maladjusted, worn or loose
, True or false? Vibration at high speed can be caused by an incorrect rear "U" joint
operating angle - ANSWERS-True
A squeaking noise in reverse is caused by... - ANSWERS-A worn cross shaft bearing
surface
A transfer case will not shift from the low gear ratio up to direct drive or 1:1 ratio.
Which of the following is the MOST likely cause?
a. Broken shift shaft spring
b. Faulty shift indicator
c. Damaged planetary gearset
d. Broken shift shaft - ANSWERS-d. Broken shift shaft
Noise: In gear, clutch disengaged (pedal to floor) - ANSWERS-Pilot bushing or
bearing
Noise: Neutral, clutch disengaged (pedal to floor) - ANSWERS-Release bearing
Noise: Neutral, clutch engaged (pedal up) - ANSWERS-Input shaft bearing
Binding U-Joint will damage?? - ANSWERS-Extension housing bushing and seal
