• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 2 out of 5 pages
Exam (elaborations)

ASE certification study guide with complete solutions

Document preview thumbnail
Preview 2 out of 5 pages

ASE certification study guide with complete solutions Spark plugs are being replaced on a v6 engine. Which of the following should be performed before removing the boot? - Answer-Twist the boot 1/2 a turn Technician A days that a positive crankcase ventilation (pvc) system reduces vehicle emissions. Tech B says that a pvc system helps increase crankcase pressure. Who is correct? - Answer- Tech A Tech A says that secondary ignition wires should be inspected when replacing spark plugs. Tech B says that if a new spark plug is dropped it can be used as long as the gap doesn't change. Who is correct? - Answer-Tech A Incorrect valve timing could be caused by... - Answer-Incorrect timing belt position When measuring parallelism of a disc brake rotor, A technician measures 0.002" variation beyond the specification. The next step is to? - Answer-Determine the minimum rotor machine to thickness Tech A says that disconnecting the negative battery cable may be required to disable the air bag system. Tech B says that a self powered test light can be used to test air bag system components. Who is correct? - Answer-Tech A only EMILLECT 2024/2025 ACADEMIC YEAR ©2024 EMILLECT. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER, 2024 Page 2/5 A vehicles battery prematurely fails. A charging system output test shows the alternator is producing a constant 16.0 volts. This could indicate a failed... - Answer-Voltage regulator A dirty cabin air filter can cause... - Answer-A musty smelling cabin Define the term stroke - Answer-Distance the piston travels from TDC (top dead center) to BDC (bottom dead center) A vehicle is being checked for power steering leaks Technician A says that leaks can develop in the fitting hoses and seals, Technician B says that the steering components should be observed for leaks while a helper turns the steering wheel from side to side. Who is right? - Answer- Both Brake fluid must meet minimum standards set by... - Answer-Department of traffic (DOT) A flexible rubber brake line is being inspected. Technician A says small blisters in the rubber are acceptable if they are not leaking. Technician B says that small cracks in the rubber require replacement of the hose. Who is correct? - Answer-Technician B only A technician is preforming a service on a vehicle there is a risk of splashing liquid. Technician A says that regular safety glasses with side shields will work. Tech B says that goggles combined with a face shield will provide adequate protection. Who is correct? - Answer-Tech B EMILLECT 2024/2025 ACADEMIC YEAR ©2024 EMILLECT. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER, 2024 Page 3/5 A band type TPMS (tire pressure monitor system) is being installed in the center of the rim. How many degrees form the valve stem should the sensor be mounted? - Answer-180 (sensor and valve stem should be parallel with each other) When a technician is working on a vehicle any of these surface protectors could be used EXCEPT? - Answer-Fender covers Paper floor mats Plastic seat covers •Lab coats answer Technician A says that worn springs can affect ride height. Tech B says that worn stabilizer bushings can affect ride height. Who is correct? - Answer-Tech A An oil filter bypass valve? - Answer-Protects the engine fro

Content preview

EMILLECT 2024/2025 ACADEMIC YEAR ©2024 EMILLECT. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER, 2024




ASE certification study guide with
complete solutions

Spark plugs are being replaced on a v6 engine. Which of the following should be performed

before removing the boot? - Answer✔✔-Twist the boot 1/2 a turn


Technician A days that a positive crankcase ventilation (pvc) system reduces vehicle emissions.

Tech B says that a pvc system helps increase crankcase pressure. Who is correct? - Answer✔✔-

Tech A


Tech A says that secondary ignition wires should be inspected when replacing spark plugs. Tech

B says that if a new spark plug is dropped it can be used as long as the gap doesn't change. Who

is correct? - Answer✔✔-Tech A


Incorrect valve timing could be caused by... - Answer✔✔-Incorrect timing belt position


When measuring parallelism of a disc brake rotor, A technician measures 0.002" variation

beyond the specification. The next step is to? - Answer✔✔-Determine the minimum rotor

machine to thickness


Tech A says that disconnecting the negative battery cable may be required to disable the air bag

system. Tech B says that a self powered test light can be used to test air bag system

components. Who is correct? - Answer✔✔-Tech A only



Page 1/5

, EMILLECT 2024/2025 ACADEMIC YEAR ©2024 EMILLECT. ALL RIGHTS RESERVED FIRST PUBLISH OCTOBER, 2024


A vehicles battery prematurely fails. A charging system output test shows the alternator is

producing a constant 16.0 volts. This could indicate a failed... - Answer✔✔-Voltage regulator


A dirty cabin air filter can cause... - Answer✔✔-A musty smelling cabin


Define the term stroke - Answer✔✔-Distance the piston travels from TDC (top dead center) to

BDC (bottom dead center)


A vehicle is being checked for power steering leaks Technician A says that leaks can develop in

the fitting hoses and seals, Technician B says that the steering components should be observed

for leaks while a helper turns the steering wheel from side to side. Who is right? - Answer✔✔-

Both


Brake fluid must meet minimum standards set by... - Answer✔✔-Department of traffic (DOT)


A flexible rubber brake line is being inspected.


Technician A says small blisters in the rubber are acceptable if they are not leaking.


Technician B says that small cracks in the rubber require replacement of the hose.


Who is correct? - Answer✔✔-Technician B only


A technician is preforming a service on a vehicle there is a risk of splashing liquid. Technician A

says that regular safety glasses with side shields will work. Tech B says that goggles combined

with a face shield will provide adequate protection. Who is correct? - Answer✔✔-Tech B




Page 2/5

Document information

Uploaded on
October 15, 2024
Number of pages
5
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers
$10.49

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
Emillect
3.0
(4)
Sold
34
Followers
2
Items
2999
Last sold
4 months ago




Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions