100% satisfaction guarantee Immediately available after payment Both online and in PDF No strings attached 4.6 TrustPilot
logo-home
Exam (elaborations)

NCCER INDUSTRIAL EXAM STUDY GUIDE QUESTIONS AND ANSWERS

Rating
-
Sold
-
Pages
7
Grade
A+
Uploaded on
29-08-2024
Written in
2024/2025

NCCER INDUSTRIAL EXAM STUDY GUIDE QUESTIONS AND ANSWERS

Institution
NCCER
Course
NCCER









Whoops! We can’t load your doc right now. Try again or contact support.

Written for

Institution
NCCER
Course
NCCER

Document information

Uploaded on
August 29, 2024
Number of pages
7
Written in
2024/2025
Type
Exam (elaborations)
Contains
Questions & answers

Subjects

Content preview

NCCER INDUSTRIAL EXAM STUDY
GUIDE QUESTIONS AND ANSWERS
multiple chemical sensitivity - Answer-Persons who perceive they are vulnerable to
exposure to certain chemicals and / or combinations of chemicals may suffer from

more susceptible to poor IAQ - Answer-Buildings that have low air - exchange rates are

20 percent - Answer-A building is said to have sick - building syndrome when more than
what percent of its occupants complain during a two - week period of symptoms that are
alleviated when the occupants leave the building ?

occur after a single , high - dose exposure - Answer-Short - term or immediate effects of
human exposure to poor IAQ may

cancer - Answer-Which of the following is a possible long - term effected of exposure to
indoor air pollutants ?

IEQ - Answer-IAQ is an integral part of

prevailing wind conditioned at the site - Answer-To get proper ventilation - damper
building's HVAC equipment , once should consider outside - air duct locations ,
neighboring pollutant orientation and adequate filtration systems into the design of a
new sources and the

Achieving good indoor air quality begins with initial building design , sitting , and
construction - Answer-Which of the following is a true statement ?

1,000 - Answer-A ventilation problem may exist when the carbon dioxide level in a room
exceeds how many parts per million (ppm) ?

soil and rocks - Answer-The most common source of radon is uranium in

sub - slab depressurization - Answer-Which of the following is a common method for
reducing radon in a building ?

the breathing of the building's human occupants - Answer-High levels of carbon dioxide
in a building can result from

properly sealing all ducts during installation - Answer-The best solution to air - duct
leakage problems is

bacteria - Answer-Ultraviolet light is used to control

gaseous vapors - Answer-Activated charcoal filters are used mainly to remove

, If an HVAC contractor detects an IAQ problem during routine maintenance , the
contractor - Answer-Which of the following statements is true ?

replaced - Answer-To control microbial contaminants , water - damaged ceiling tiles
should be

locate outside air intakes away from where motor vehicle emissions collect - Answer-
One way to prevent chemical contaminants from degrading a building's indoor air quality
is to

properly balancing the building's air supply and the exhaust system - Answer-IAQ
problems resulting from teh creation of negative pressure areas in a building due to
insufficient outdoor makeup air may be corrected by

air handling and VAV systems - Answer-An automated building - management system
communicates directly with the building's

dry bulb - Answer-What scale on a psychrometric chart can also be referred to as the
sensible heat scale ?

specific density - Answer-The measure of the weight of air in pounds for every cubic
foot of space occupied by air is called its

relative humidity - Answer-A ratio expressed in percentage of the amount of moisture
present in the air to amount it can hold at saturation is called

lower - Answer-Compared to an air handler in a high mountain cabin , what are the
airflow requirements per ton of cooling of an identical air handler installed in a seaside
cottage ?

blower inlet - Answer-The lowest air pressure in an air distribution system is found at the

14.7 psia - Answer-At sea level , every square inch of the earth has an absolute
pressure of

heater volts , amps , and AT - Answer-The values needed to calculate air volume ( cfm )
delivered by an air handler equipped with electric heaters are

6 inches - Answer-What is the maximum distance between pitot tube measuring points
in rectangular ducts ?

is decreased - Answer-If the speed of a blower used to move air through a duct is
decreased , the horsepower requirement of the motor

total pressure - Answer-The inner impact tube of a pitot tube measures

Get to know the seller

Seller avatar
Reputation scores are based on the amount of documents a seller has sold for a fee and the reviews they have received for those documents. There are three levels: Bronze, Silver and Gold. The better the reputation, the more your can rely on the quality of the sellers work.
biggdreamer Havard School
View profile
Follow You need to be logged in order to follow users or courses
Sold
250
Member since
2 year
Number of followers
68
Documents
18050
Last sold
1 week ago

4.0

38 reviews

5
22
4
4
3
6
2
2
1
4

Recently viewed by you

Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Frequently asked questions