Who is the third party group that approves and endorses standards? Correct
Answer-American National Standards Institute
What term is used to describe the documents written by members, or peers, in
the industry? Correct Answer-Standards
A company's health, safety and environment policy should be a combination of
labor regulations and ? Correct Answer-Industry standards
Where OSHA has not promulgated specific standards, who is responsible for
following the acts general clause? Correct Answer-Employer
On a job site who should be involved in the JHA process? Correct Answer-The
Whole Crew
What does the Term SOW stand for? Correct Answer-Scope Of Work
The letters JHA stand for what ? Correct Answer-Job Hazard Assessment
, TTT1 Study guide; Questions and Answers
When using a extension ladder, how many feet past the platform must it
extend? Correct Answer-3
If you have a sixteen foot ladder leaning against a building wall, how many feet
from the wall does the case need to by to have the correct slope? Correct
Answer-4
Work boots with ankle support are recommended for all work sites? Correct
Answer-True
What do the letters PPE stand for ? Correct Answer-Personal Protective
Equipment
What does the ground fault circuit interrupter (GFCI) do? Correct Answer-
Senses a short circuit, prevents electrocution , shuts off the flow of electricity
Who is responsible for providing PPE? Correct Answer-Employer
When using a y-lanyard attached to your back d-ring, at what height should the
connection to your anchorage be placed?extend? Correct Answer-Shoulder
level or above