OSHA Basic Orientation Plus Latest Update
2024-2025 150 Questions and 100% Verified
Correct Answers Actual Exam Guaranteed A+
A vertical barrier at floor level erected along exposed edges of a floor opening wall
opening, platform, runway, or ramp to prevent falls of materials. - CORRECT ANSWER:
Toe board
always test the atmosphere in the work area prior to starting the job when the site is
greater than how many feet? - CORRECT ANSWER: four
Facilities are not permitted to control your entrance and exit in covered process areas. -
CORRECT ANSWER: False
For an excavation that is 4 feet deep or more, egress points must be spaced no more
than how many feet of lateral travel for employees? - CORRECT ANSWER: 25
if you are replacing a piece of equipment the new one should be the same as the one
being removed. If its not you should find out whether the change was on purpose. what
is this called - CORRECT ANSWER: Management of change
If you experience pain or discomfort as a result of your work activities, you should do
what? - CORRECT ANSWER: report it to your supervisor as soon as possible
In an emergency you should call emergency response with the - CORRECT ANSWER:
Exact location, number of victims
Excavation measurements, special hazards at the location
In the PSM standard OSHA states employees must be trained if they work with highly
hazardous chemicals. - CORRECT ANSWER: True
, In what section of the SDS can you find the hazards of hydrogen sulfide - CORRECT
ANSWER: Section 2
It is your responsibility to follow all safety regulations, inform your employer of any
unsafe condition; report all injuries no matter how minor they seem and wear the proper
personal protective equipment? - CORRECT ANSWER: True
narrow excavation made below the surface of the ground in which the depth is usually
greater than the width and the width does not exceed how many fee? - CORRECT
ANSWER: 15
Obstacles that discourage the passage of persons or vehicles - CORRECT ANSWER:
Barricade
Physical devices that are designed to prevent entry into an area where hazards are
present. - CORRECT ANSWER: Barriers
Physical/health hazards cause illness or injury - CORRECT ANSWER: True
The OSHA standard that addresses the requirements for preventing and lessening the
results of a bad release of toxic, reactive, flammable, or highly explosive hazardous
chemicals from a process - CORRECT ANSWER: Process safety management
Standard
The process Hazard Analysis (PHA) is one of the most important parts of the PSM
program. PHAs are used to identify and evaluate major processes and ensure they are -
CORRECT ANSWER: Evaluated, Controlled, and Identified
Under the Stop Work Authority, you have the right and obligation to stop a work activity
if you have reason to believe your own safety or a coworkers safety is in jeopardy or if
the work plan is not clearly established or understood . - CORRECT ANSWER: True
2024-2025 150 Questions and 100% Verified
Correct Answers Actual Exam Guaranteed A+
A vertical barrier at floor level erected along exposed edges of a floor opening wall
opening, platform, runway, or ramp to prevent falls of materials. - CORRECT ANSWER:
Toe board
always test the atmosphere in the work area prior to starting the job when the site is
greater than how many feet? - CORRECT ANSWER: four
Facilities are not permitted to control your entrance and exit in covered process areas. -
CORRECT ANSWER: False
For an excavation that is 4 feet deep or more, egress points must be spaced no more
than how many feet of lateral travel for employees? - CORRECT ANSWER: 25
if you are replacing a piece of equipment the new one should be the same as the one
being removed. If its not you should find out whether the change was on purpose. what
is this called - CORRECT ANSWER: Management of change
If you experience pain or discomfort as a result of your work activities, you should do
what? - CORRECT ANSWER: report it to your supervisor as soon as possible
In an emergency you should call emergency response with the - CORRECT ANSWER:
Exact location, number of victims
Excavation measurements, special hazards at the location
In the PSM standard OSHA states employees must be trained if they work with highly
hazardous chemicals. - CORRECT ANSWER: True
, In what section of the SDS can you find the hazards of hydrogen sulfide - CORRECT
ANSWER: Section 2
It is your responsibility to follow all safety regulations, inform your employer of any
unsafe condition; report all injuries no matter how minor they seem and wear the proper
personal protective equipment? - CORRECT ANSWER: True
narrow excavation made below the surface of the ground in which the depth is usually
greater than the width and the width does not exceed how many fee? - CORRECT
ANSWER: 15
Obstacles that discourage the passage of persons or vehicles - CORRECT ANSWER:
Barricade
Physical devices that are designed to prevent entry into an area where hazards are
present. - CORRECT ANSWER: Barriers
Physical/health hazards cause illness or injury - CORRECT ANSWER: True
The OSHA standard that addresses the requirements for preventing and lessening the
results of a bad release of toxic, reactive, flammable, or highly explosive hazardous
chemicals from a process - CORRECT ANSWER: Process safety management
Standard
The process Hazard Analysis (PHA) is one of the most important parts of the PSM
program. PHAs are used to identify and evaluate major processes and ensure they are -
CORRECT ANSWER: Evaluated, Controlled, and Identified
Under the Stop Work Authority, you have the right and obligation to stop a work activity
if you have reason to believe your own safety or a coworkers safety is in jeopardy or if
the work plan is not clearly established or understood . - CORRECT ANSWER: True
