Exam Questions And Answers. Verified And
Updated.
(Fuel) How is fuel heated prior to entering the engine? - answer✔✔Via a Fuel/Oil heat
exchanger using hot engine oil
(Fuel) The _______ Status message appears if the fuel service panel is switched on. -
answer✔✔AUTO XFLOW INHIBIT
(Fuel) The Main, Scavenge and Transfer ejectors are powered by? - answer✔✔Motive flow
(Fuel) When selected to AUTO, The Fuel Control Computer will activate Powered Crossflow
when a fuel imbalance of _____ develops and shut off when the previously low tank is ______
lbs. above the opposite tank. - answer✔✔200 lbs. / 50 lbs.
(Fuel) Takeoff is prohibited with engine fuel temperature indications below _____. -
answer✔✔5°C
(Fuel) The Fuel Check valve check conducted on the first flight of the day ensures fuel pressure
from the ____ cannot supply fuel to the opposite side engine. - answer✔✔Operating engines
Main Ejector
(Fuel) If the bi-directional crossflow pump fails, the alternative method to balance fuel is.... -
answer✔✔Gravity Crossflow
(Lighting) The NAV lights are powered from the DC Service bus. If the DC Service switch is
left on, the ____ battery will be discharged. - answer✔✔APU
(Lighting) When the aircraft is stationary, operation of the Taxi lights is limited to ____. -
answer✔✔10 Minutes
(Lighting) T or F? Landing light lenses are diffused, Taxi Lights are clear. - answer✔✔False
(Lighting) The Flight Data Recorder is activated when the following switches are selected. -
answer✔✔Beacon or Strobes.
(Lighting) Emergency lights are powered from __________ batteries and will provide lighting
for ______ minutes. - answer✔✔Rechargeable, 10
EXAM STUDY MATERIALS July 25, 2024 1:06 PM
, (Automatic Flight Control System) Half Bank mode when selected reduces maximum bank angle
to ______. - answer✔✔15 degrees
(Automatic Flight Control System) What is indicated by the illumination of the green lights
located to the sides of the mode select buttons on the FCP? - answer✔✔Both FCC's agree the
mode selected is acceptable for the aircraft's current condition
(Automatic Flight Control System) After takeoff, speed mode is selected what occurs? -
answer✔✔Vertical mode changes to CLB, current IAS is referenced and displayed on the FMAs
(Automatic Flight Control System) What information is provided by the Flight Mode
Annunciator (FMA)? - answer✔✔Flight Director modes
(Automatic Flight Control System) T or F? In order for the Autopilot to engage, both Flight
Control Computers must be functional. - answer✔✔True
(Automatic Flight Control System) T or F? In addition to its' function as an autopilot disconnect,
the red AP/SP button on the control yoke will also override the Stick Pusher. - answer✔✔True
(Aircraft General) Where can the Emergency Evacuation Procedure be found? - answer✔✔On
the QRC and cover of the QRH
(Aircraft General) The maximum altitude to operate the Aircraft is _________. -
answer✔✔41,000 feet
(Aircraft General) T or F? The Doors displayed on the Doors synoptic page are all located within
the pressure vessel. - answer✔✔True
(Aircraft General) What is minimum amount of pavement needed to make 180° turn in CRJ 700
and 900? - answer✔✔75 ft. & 80 ft.
(Aircraft General) The Maximum load allowed on the Passenger door is _____ ? - answer✔✔4
passengers / 1000 lbs.
(Aircraft General) T or F? The Aft Equipment Bay door is hinged forward, if the door becomes
unlatched in flight the door should blow closed to prevent damage. - answer✔✔True
(Landing Gear) T or F? The landing gear is electrically controlled by the PSEU, Hydraulic
system 2 normally supplies the hydraulic pressure to operate. - answer✔✔False
(Landing Gear) T or F? When a manual gear extension is performed, hydraulic system Two
operates the Nose the NLG release actuator and MLG aux actuators (if installed) -
answer✔✔True
(Landing Gear) Normally hydraulic system Three releases the over-center up-lock on the Nose
landing gear allowing extension. Hydraulic system _______ or _______ must be available to
lower the Nose landing gear. - answer✔✔3 or 2
EXAM STUDY MATERIALS July 25, 2024 1:06 PM