FANUC Post Test /20 Questions and Answers

FANUC Post Test /20 Questions
and Answers
Enabling the iPendant gives motion solely to whom?
A. The PLC
B. The Controller
C. The Operator
D. Andy from accounting - -C. The Operator (person with the pendant) -Assuming standard setup, if you jog the robot in World -Y which direction will the TCP move?
A. Straight up B. Up
C. To the robots right D. To the robots left - -C. To the robots right -What key is depressed to switch between the different jog methods?
A. POSN
B. MENU
C. FCTN
D. COORD - -D. COORD -What two buttons display the Jog Menu?
A. Shift and Display B. Menu and any job key C. Shift and COORD
D. Group and COORD - -C. Shift and COORD -What type of memory is saved when performing an Image Backup?
A. F-ROM Only
B. SRAM Only
C. F-ROM and SRAM D. DRAM - -C. F-ROM and SRAM -Singularity error can be corrected by moving?
A. Joint 2 (+/-) 10 degrees B. Joint 3 (+/-) 15 degrees C. Joint 5 (+/-) 10 degrees D. Joint 6 (+/-) 15 degrees - -C. Joint 5 (+/-) 10 degree -Where us the default Tool Center Point? A. Intersection of J1 and J2 B. Center of the Faceplate