8.2.5 OSPFV3 QUESTIONS & ANSWERS VERIFIED 100% CORRECT!!

After OSPFv3 has been enabled on a router. You need to set the router ID. Which command will accomplish this task? - router-id [ID number] If you have multiple IPv6 address prefixes on a single OSPF interface, which of the following statements are true? (Select two.) - All address prefixes on an interface are included by default. Users cannot select some address prefixes to be imported into OSPF for IPv6; either all address prefixes on an interface are imported, or no address prefixes on an interface are imported. In OSPFv3, which term is used to define the communication medium used between nodes at the Link layer? - Link Match each OSPFv3 command on the left with the corresponding description on the right. Each command may be used once, more than once, or not at all. - Enables OSPF for IPv6 router configuration. ipv6 router ospf [process id] Generates a default external route into an OSPF routing domain. default-information originate Displays the current contents of the IPv6 routing table. show ipv6 route Enables OSPFv3 for IPv6 on an interface. ipv6 ospf [process id] area [number] Which command is used to enable OSPFv3 on a router? - router ospfv3 [process ID] Which of the following indicate changes between OSPFv2 and OSPFv3? - The term link replaces the terms subnet and network when defining the medium used to communicate between nodes at the Link layer.Which of the following is true about address prefixes for OSPFv3 interfaces? (Select two.) - You cannot choose which address prefixes to import into OSPF for IPv6. All address prefixes are included by default. Which of the following statements are true regarding OSPFv3 LSAs? (Select two.) - Type 9 is an intra-area prefix LSA. Type 8 is a link LSA. You have configured an OSPFv3 router interface as a passive interface. Which of the following is true? - The interface advertises all subnets connected to the interface. You would like to enable an OSPFv3 routing process on a single interface and begin to use route IPv6 traffic. Which command(s) would you use? - Router(config-if)#ipv6 ospf [process id] area [number]