Gypsum Construction Handbook Exam Questions And Answers 100% Verified.

Gypsum Construction Handbook Exam Questions And Answers 100% Verified. _____ fastener should be used when 3/8", 1/2" and 5/8" single layer gypsum panels are attached to wood framing. A. 1-1/2" Type G bugle head B. 1-1/4" Type S bugle head C. 1-1/8" Type S bugle head D. 1-1/4" Type W bugle head - answerD. 1-1/4" Type W bugle head pg 39 _____ is/are warning signs of fastener imperfections. A. Darkening B. Localized cracking C. Protrusion of the fasteners D. All of the above - answerD. All of the above pg 370 Extended periods of _____ will discolor panel face paper. A. High humidity B. Low humidity C. Cold weather D. Strong sunlight - answerD. Strong sunlight pg 355 3/8-inch gypsum panels are designed for framing centers up to _____. A. 24 inches B. 16 inches C. 20 inches D. 12 inches - answerB. 16 inches pg 3 _____ is often caused by excessively fast drying of joint compounds. A. Loose panels B. Board sagging C. Joint cracking D. None of the above - answerC. Joint cracking pg 370 Use _____ screw to connect 3/4 inch single-layer panels to steel studs. A. 1 inch Type S bugle head B. 1-1/8 inch Type S bugle head C. 1-1/4 inch Type S bugle head D. 2-1/4 inch Type S bugle head - answerC. 1-1/4 inch Type S bugle head pg 38 Stack panels face up with ends resting on nominal 2" x 4" lumber and with center of the boards resting on floor, and allow to remain overnight or until they have _____. A. A 1" space between adjacent panels B. At least a 2" permanent bow C. No stains or discoloration on face paper D. All of the above - answerB. At least a 2" permanent bow pg 112 Maintain and control heat in the range of 55F to 70F for 24 hours _____ the entire gypsum board finishing process. A. Before B. During C. After D. All of the above - answerD. All of the above pg 103 Board sags in ceiling are often caused by _____. A. Improperly fitted panels B. Insufficient support of board C. High-humid conditions D. All of the above - answerD. All of the above pg 371 Long partition runs shall have _____ to compensate for hygrometric and thermal expansion. A. Relief joints