Electrical level 3 Module 6
How do you check ohms of switchgear - ANS1000v megger
What is the abbreviation for a coil on electrical drawings - ANSCC
NEC requires neutrals to have a continuous marking of white or tape for #6 and smaller -
ANSGrey
What is the abbreviation for an oscilloscope - ANSCRO
Non standard abbreviations used on drawings are typically defund in the what - ANSLegend
The continuous current that a circuit breaker can carry without exceeding a standard temp rise
is known as the - ANSRated current
Connection diagrams should be used to show - ANSInternal wiring connections/diagram
Which of the following tests is conducted in order to detect loose connections? - ANSHeat
scanning test
The voltages and amps used in primary circuits of sub stationing are reduced to useable levels
by - ANSInstrument transformer
Wires from a sensor to a ground fault really should be no longer than - ANS25'
The most important consideration for selecting a current transformer for relating is the -
ANSSaturation level
The basic purpose of a switchgear is - ANSTo provide power system protection by automatically
isolating faults
Circuit breakers are given on - ANSThe nameplate
Field marking of service equipment shall include the - ANSDate fault current was tested
What is the standard output of a PT - ANS120v
What is the usual output of a CT - ANS0-5amps
A downed power line is most likely to result in a - ANSPhase Failure
How do you check ohms of switchgear - ANS1000v megger
What is the abbreviation for a coil on electrical drawings - ANSCC
NEC requires neutrals to have a continuous marking of white or tape for #6 and smaller -
ANSGrey
What is the abbreviation for an oscilloscope - ANSCRO
Non standard abbreviations used on drawings are typically defund in the what - ANSLegend
The continuous current that a circuit breaker can carry without exceeding a standard temp rise
is known as the - ANSRated current
Connection diagrams should be used to show - ANSInternal wiring connections/diagram
Which of the following tests is conducted in order to detect loose connections? - ANSHeat
scanning test
The voltages and amps used in primary circuits of sub stationing are reduced to useable levels
by - ANSInstrument transformer
Wires from a sensor to a ground fault really should be no longer than - ANS25'
The most important consideration for selecting a current transformer for relating is the -
ANSSaturation level
The basic purpose of a switchgear is - ANSTo provide power system protection by automatically
isolating faults
Circuit breakers are given on - ANSThe nameplate
Field marking of service equipment shall include the - ANSDate fault current was tested
What is the standard output of a PT - ANS120v
What is the usual output of a CT - ANS0-5amps
A downed power line is most likely to result in a - ANSPhase Failure
