A2 Automatic Transmission/Transaxle Questions And Answers 2024

A2 Automatic Transmission/Transaxle Questions And Answers 2024 To achieve the output forces shown in the illustration above, how much applying force should be used? A. 5lbs B. 10lbs C. 15lbs D. 20lbs - ANS-D. 5 lbs The malfunction indicator light is illuminated on a vehicle presented for service and the customer complains of transmission problems. A scan tool reveals that there are both engine and transmission related diagnostic trouble codes. Technician A says that the engine related DTCs should be serviced first. Technician B says that engine related DTCs have no effect on transmission performance. Who is right? - ANS-Technician A only Technician A says that, when checking for voltage in a sensor circuit of an electronic transmission control system, a test light should be used. Technician B says that a known good ground should be touched before replacing the sensor. Who is right? - ANS-Technician B only Technician A says that the illustration above shows the correct way to measure the clearance of a multiple disc clutch assembly. Technician B says if clearance is incorrect it can be restored using a different thickness snap ring. Who is right? - ANS-Both technicians A front wheel drive vehicle with an automatic transaxle has excessive vibration. Technician A says that the vibration could be caused by worn engine/transaxle mounts. Technician B says that the vibration could be caused by a misaligned engine/transaxle sub-frame. Who is right? - ANS-Both technicians A vehicle with an automatic transmission is experiencing harsh upshifts and downshifts with no DTCs. During the line pressure test, the line pressure, as commanded by a scan tool, does not match the pressures shows on a pressure gauge. Technician A says the pressure control solenoid electrical circuits CONTINUES...