FANUC certification final
Turning the Teach Pendant on: - ANS-Gives motion control solely to the operator via the
teach pendant
What must be accomplished to avoid hard-stops and over travels? - ANS-Set Axis
Limits
SHIFT and the hard key COORD will display the following menu: - ANS-The "jog" menu
SHIFT and POINT are needed to do what? - ANS-Record the current position of the
robot
In the motion command "J P [2] 100% FINE", If you wanted to change the "FINE"
component to a "CNT100" what buttons would you press? - ANS-Select component,
then press [CHOICE]
To switch manually from one program to another, you have to be in which screen? -
ANS-Select
How many Robot I/O points are standard on a controller? - ANS-16
Which soft key is pressed to display the current motion instruction defaults from the
EDIT Screen? - ANS-POINT
When creating a program, which hard key should be pressed? - ANS-Select
When using the Prog Adjust utility, which statement is correct? - ANS-Pressing
CLR_ADJ or CLR_ALL will save the enabled data values
Which of the following tasks can be performed from the FILE Menu? - ANS-Get a
default directory of the device
If while jogging the robot, you get an "in singularity" error, What must you do? -
ANS-Joint jog J5 +/- at least 10 degrees
The"Program Header Information" at the DETAIL softkey enables you to modify the
following program information, EXCEPT: - ANS-Active tool frame
Turning the Teach Pendant on: - ANS-Gives motion control solely to the operator via the
teach pendant
What must be accomplished to avoid hard-stops and over travels? - ANS-Set Axis
Limits
SHIFT and the hard key COORD will display the following menu: - ANS-The "jog" menu
SHIFT and POINT are needed to do what? - ANS-Record the current position of the
robot
In the motion command "J P [2] 100% FINE", If you wanted to change the "FINE"
component to a "CNT100" what buttons would you press? - ANS-Select component,
then press [CHOICE]
To switch manually from one program to another, you have to be in which screen? -
ANS-Select
How many Robot I/O points are standard on a controller? - ANS-16
Which soft key is pressed to display the current motion instruction defaults from the
EDIT Screen? - ANS-POINT
When creating a program, which hard key should be pressed? - ANS-Select
When using the Prog Adjust utility, which statement is correct? - ANS-Pressing
CLR_ADJ or CLR_ALL will save the enabled data values
Which of the following tasks can be performed from the FILE Menu? - ANS-Get a
default directory of the device
If while jogging the robot, you get an "in singularity" error, What must you do? -
ANS-Joint jog J5 +/- at least 10 degrees
The"Program Header Information" at the DETAIL softkey enables you to modify the
following program information, EXCEPT: - ANS-Active tool frame
