Automotive Collision ASE Practice Exam 100% Accurate!

Automotive Collision ASE Practice Exam 100% Accurate Technician A says that when replacing metal parts, an anti-corosion material should be applied. Technician B says that some adhesive products may contain anti-corrosion properties. Who is right? A. A only B. B only C. Both A and B D, Neither A nor B - ANSWERC. Both A and B Technician A says that humidity can influence the rate of corrosion. Technician B says that cold temperatures can accelerate the rate of corrosion. Who is right? A. A only B. B only C. Both A and B D. Neither A nor B - ANSWERA. A only Which of these is the best method to correct a filler weld with too little penetration? A. Increase the stick-out and increase the wire feed B. Increase the drive roll pressure and decrease the stick-out C. Decrease the drive speed and increase the heat and wire feed D. Increase the drive speed and decrease the stick-out - ANSWERA. increase the stick-out and increase the wire feed Which of these tools should be used to metal finish a damaged panel? A. Pick hammer and a vixen file B. A grater and in-line sander C. An electric sander with 16-grit sandpaper D. A stud pin welder - ANSWERB. A grater and in-line sander Which of these characteristics would be the most noticeable difference when metal finishing aluminum versus steel? A. Work hardening B. Ambient temperature C. Location of damage D. Alloy composition - ANSWERD. Alloy composition When used to cut off a metal panel which of these tools would generate the least amount of heat? A. cut-off wheel B. Plasma cutting torch C. Air saw D. Oxyacetylene cutting torch - ANSWERA. Air saw Which of these products can be applied over the manufacturer's finish? A !