ASE MLR Certification TestGuide With Verified Answers

Both A and B -Answer Technician observes that the brake fluid level is at the "Min" mark in the master cylinder reservoir. Tech A says that worn front pads could be the cause. Tech B says that a leak in the brake hydraulic system could be the cause. Who is right? A only -Answer The tires of a vehicle are being rotated and balanced. Tech A says that the wheel weight retaining clips must be matched to the rim profile. Tech B says that directional tires are rotated in a criss-cross pattern. Who is right? Safely exit the building -Answer When a shop fire cannot be immediately contained, the best thing to do is warn others in the area, and: 300 amps for 15 seconds -Answer A fully charged battery rated at 600 CCA, the ambient temperature is 70 degrees which of these current and time periods should be used? B only -Answer A vehicle's halogen headlamp bulbs are being replaced. Technician A says the glass part of the bulb can only be handled with bare hands. Technician B says the headlamp may need to be removed. Who is right? 0.728 -Answer On a Metric Micrometer upper sleeve reading 5.0mm with lower sleeve reading 0.50mm and a thimble reading of 0.01mm what is the overall reading? A only -Answer The fuel filter on a fuel-injected vehicle is being replaced. Tech A says the fuel pressure should be relieved before removing the filter. Tech B says that the arrow on the fuel filter should point towards the fuel tank. Who is right? The brake pedal feels low and spongy -Answer Which of these is an indication of air in the brake hydraulic system? Anaerobic -Answer Which of these cures in the absence of air? Fluid contaminated brake linings -Answer A grabbing brake condition can be caused by any of these EXCEPT: Visually verify that the oil filter gasket is properly installed -Answer When performing an oil filter change on a vehicle with a spin on oil filter, the technician must: Voltage regulation -Answer A vehicle's battery prematurely fails. A charging system output test shows the generator (alternator) is producing a constant 16.0 volts. This could indicate a failed: Seal should be lubricated with transmission fluid