Linux 4.4.6 TestOut Questions and Answers Rated A+

Linux 4.4.6 TestOut Questions and Answers Rated A+ What is another term used when referring to Linux services running under systemd? Daemon You are working on a systemd-based Linux distribution. Which command can you use to manage the services and targets? systemctl Your system is currently running the t. You want to enable ce to run when t is loaded. There are two commands you must enter from a command prompt to accomplish this task. Drag the commands on the left to the appropriate step number on the right. (Not all of the commands on the left will be used.) Step One systemctl isolate t Step Two systemctl enable ce Your system is currently running the t. What would you enter at the command prompt to find out whether the ce is configured to start every time the t is loaded? systemctl is-enabled ce You want to prevent the ce daemon from starting at all on your Linux server. What command would you enter to perform this task? systemctl mask ce You are working on a Linux server that uses systemd. You have made changes to the firewall settings. What systemctl command can you enter to implement the changes on the server without stopping the firewall? systemctl reload ce After making changes to the configuration of ce, you must make those changes take effect. Which single command can you enter to force the service to use the new configuration?(Note that there is no reload option with this service.) systemctl restart ce After getting calls about users not being able to print, you check the status of ce and find that it is not running. What would you enter at the command prompt to run ce? systemctl start ce What would you enter at the command prompt to determine whether ce is running? systemctl status ce You notice that the ntpd service is no longer running on your Linux server. You try using the systemctl start and systemctl restart commands to start the service running again. However, the service refuses to start. Which of the following systemctl commands could you try using to make the ntpd service available for starting or restarting? systemctl