Imsa Signal Technician Level 1 Final Exam / 80+ Well Structured Questions And Verified Solutions 2024/2025

1. What is the primary function of the IMSA?: Safety education 2. IMSA stands for:: International Municipal Signal Association 3. Which of the following is NOT an IMSA certification?: Y:Traffic Signal Level IIDesign/Engineer Technician Y: Traffic Signal Level II Field Technician Y:Traffic Signal Level II Bench Technician N:Traffic Signal Level III Bridge Design Technician 4. Which of the following are potential safety hazards?: Overhead and under-ground power Gas Aerial lift equipment 5. What are the sections of a ramp meter signal?: Circular red, circular green 6. PPE stands for:: Personal Protective Equipment 7. Which of the follow is an example of adequate fall protection during theoperation of aerial lift equipment?: Full body harness Safety belt Rails of a platform lift 8. Work Zone Supervisor is responsible for which of the following tasks?: En-sure advance warning devices have not been removed or relocated 9. Which of the following is NOT a sentence type in the MUTCD?: Y:Standards;requirements that have to be followed Y:Guidance;recommendationsthat are to be followed unlessthere is a good reasonnot to N: Objectives; reasons behind the standards and guidance y: Support; additional information to clarify the standards and guidance 10. Which of the following is an example configuration of an Emergency-Ve- hicleTraffic Control Signals:: Three-section traffic signal with circular red, circularyellow, and smaller circular yellow indications 11. The following phases are typically assigned to the major street throughmovements:: 2 and 6 12. The green interval is made up which three components?: Minimum green,passage time, maximum green 13. What are the three types of recall features of a traffic signal controller?: - 3 / 6 Minimum, maximum, pedestrian (+soft) 14. In a coordination plan,what is the number of seconds given to each phaseat the intersection?: Split (g,y,r) 15. Which of the following traffic signal coordination method is typically leastexpensive?: Time-based coordination