API 510 Practice Test (Referenced) 100% Solved 2024
API 510 Practice Test (Referenced) 100% Solved 2024 Substituting NDE procedures for a pressure test after major repair may be done only after: API 510 5.8.8.1 The engineer and inspector have approved. An example of vessels not covered by API 510 are: API 510 1.1.1 Vessels officially retired from service and abandoned in place. ACFM is an acronym for: ASME SEC 5 Article 15 Alternating Current Field Measurement A pneumatic testing precedure should be developed by whom before conducting the test? API 510 5.8.6 Engineer A signal of discontinuity in the material under nondestructive examination is considered: API RP 577 3.1.36 Indication In what type of service should vessels be evaluated for potential fatigue cracking failures and have appropriate inspections planned? API 510 5.4.4 Cyclic Service Corrosion and other damage identified during inspections and examinations must be characterized, sized, and evaluated per Section 7 (Inspection Data Evaluation, Analysis, and Recording) with deviations from the inspection plan being approved by whom? API 510 5.5.1 Inspector or Engineer Inspection tasks typically associated with hot tapping or welding on in-service equipment should include: API 577 11.2.5 Positive Metal Identification (PMI) Any repair welding should be performed according to a procedure accepted by the: API 510 8.1.1 Inspector or Engineer Welding of carbon steel with carbon contents over 0.30% API 510 8.1.5 May need special attention and preheating to avoid weld cracking. Inspector recommendations can be changed or deleted after review by whom? API 510 6.9 Pressure Vessel Engineer or Inspection Supervision Deposited weld metal on the face of a weld preparation or surface that will be part of a welded joint is referred to as: API 577 3.1.14
Documentinformatie
- Geüpload op
- 20 mei 2024
- Aantal pagina's
- 5
- Geschreven in
- 2023/2024
- Type
- Tentamen (uitwerkingen)
- Bevat
- Vragen en antwoorden