Asphalt Paving Level 1 || with 100% Error-free Solutions.

A full Lot of Superpave Asphalt is what size? correct answers 2,000 or 4,000 tons Which is not typically used as an asphalt binder in an FDOT Mix Design? correct answers PG 62-22 Who cuts the density cores used for Verification Testing (VT)? correct answers The Contractor True or False: A full Lot is composed of 5 Sublots and 4 Cores per LOT. correct answers False What is the most important for a consistent compaction of Asphalt Mix? correct answers The mix is uniform in Temperature Referring to General Stationing guidelines, R1 would be ___ than R2: A. Closer to the Centerline B. Closer to the Outside Shoulder C. Closer to the Inside Shoulder D. Both A & C correct answers Both A & C - Closer to the centerline & Closer to the Inside shoulder While using the rolling straightedge, if the needle goes into the red zone indicating an unacceptable high spot in the section, you then: correct answers Mark the pavement where the needle first goes into the red zone and place another mark where the needle leaves the red zone and continue. For Bridge Approach Slabs, the 15 foot Manual Straightedge should be set so ___ is on the Bridge Deck. correct answers 1 inch For the first transverse joint on a project place the ___ on the new pavement while overlapping the transverse joint by one inch. correct answers 15 Foot Manual Straightedge When calibrating, to check the LOW side of the rolling straightedge: correct answers Place a 3/16 inch shim under each OUTSIDE wheel. The gauge should read zero on both sides of the gauge. When Calibrating, to check the HIGH side of the rolling straightedge: correct answers Place a 3/16 inch shim under the CENTER wheel. The gauge should read zero on both sides of the gauge. What do you need to know when manually checking the cross slope? A. The level length B. The Lane Width C. Height from the end of the level to pavement surface D. Both A and C correct answers Both A & C - The level length and the Height from the end of the level to Pavement Surface