Nccer Millwright Practice Exam 2
unusual If the seal was not properly aligned or there is excessive wear in some bearing or shaft,_______ wear tracks will be the indicator sharpened brass putty knife For removing hard to remove gasket materials found on sealing surfaces, ______ is recommended Conducted on the job Apprenticeship training is_______ distance Charting alignment on a graph requires a chart that is divided into thousandths of an inch vertically for the indicator readings and into whole inches horizontally for the__________ hidden The orthographic drawing may contain a dashed or _______ line Radiation In order to shoot through a test object and project an image onto a detector or a sheet of film, radiography uses a source of penetrating called _______ *scribe circles *transfer measurements *compare distances measure angles Which of the following task would you not perform with dividers? 10% The over speed trip device is actuated when the turbine reaches a predetermined limit usually _________% above normal full-load speed high Positive results in an offset measurement mean that the MTBM is _____ or on the 3-o'clock side. offset m
Document information
- Uploaded on
- April 28, 2024
- Number of pages
- 12
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers
