Brake Test exam Questions with 100% Correct Answers

Turning the brake drums Correct Answer use damping strap to reduce chatter In the illustration below which of the following can you measure by the rotor Correct Answer lateral run out ABS speed sensors rings Correct Answer should not be hammered or tapered on The key input for the abs control module comes from the Correct Answer wheel speed sensors A cranked torn vacuum damper in a brake power booster would most likely cause Correct Answer a hard pedal requiring very hard pedal effort You have turned a rotor to remove score on the rotor. the thickness is now 1.155 what should you do Correct Answer Use the rotor and install new brakes Why don't disc brake systems usually need ADJ Correct Answer friction between the caliper seal and caliper position will keep the pads againist the rotor In the above drawing you would find break fluid entering at points Correct Answer 2 and 3 a common cause of pedal pulsation during brake application is Correct Answer improperly torqued wheels the tool shown below is used to Correct Answer ADJ the brake shoes to drum size which of the following incorrect service procedures will cause the brake to lock up Correct Answer master cylinder push rod ADJ too long Which of the fol;owing describes the correct sequence for bleeding brake lines on most split diagonal Correct Answer read the manufacturers recommendation, the procedure varies depending on the model Which of the following is true about bleeding brake lines on most ABS equipment vechocles Correct Answer most ABS brake lines can be bled like conventional Upon inspecting brake fluid condition tech observes a diagram master cylinder cup swollen Correct Answer petroleum produces appealed to the system In disc brake assy the square cut seal is located Correct Answer In caliper piston bore You are installing a set of brake shoe linings that are not the same length Correct Answer smaller to the front of the car