DOT Exam Questions with Correct Answers

DOT Exam Questions with Correct Answers You are asked to inspect a non-bulk package of a hazardous material being shipped as a limited quantity. Which of these marking requirements is NOT required on this package? - Answer-Identification number Marking the ORM-D designation in a rectangle following or below the proper shipping name on a nonbulk package _______________ that the package is in proper condition for transportation. The marking certification does not take the place of the shipping paper certification, if required. - Answer-certifies ______________________ are not required on packaging that contains only ORM-D materials or limited quantities - Answer-Identification Numbers The ______________________ mark must be placed in association with the hazard warning labels or the proper shipping name for non-bulk packaging containing materials listed in Appendix B to §172.101 and shipped by vessel transport - Answer-Marine Pollutant A consumer commodity prepared for air shipment in a non-bulk packaging must display the ______________________ marking - Answer-RQ,ORM-D-Air Which one of these four statements is NOT correct concerning the general marking requirements for bulk packagings of hazardous materials? - Answer-You may remove markings from a tank car marked with a proper shipping name, common name or identification number when it is emptied, and only contains residue of hazardous materials Which one of these four statements is NOT a general marking requirement for hazardous materials? - Answer-The marking must be displayed on a white or black background. A package containing an amount of Mercury compounds, solids, n.o.s., UN2025, PGIII, requiring hazard labels can be labeled with all but one of these labels. Which of these labels is NOT authorized to be used? - Answer-inhalation hazard 2 The Marine Pollutant mark is NOT required to be affixed to which one of these packagings? - Answer-On a combination packaging containing 300 grams of Copper cyanide in an inner packaging. Which bulk packaging type requires QT and NQT markings near the specification plate to indicate if it is constructed of quenched and tempered steel or not? - Answer-Cargo tanks An identification number may be displayed only on a placard corresponding to the _______________ hazard class of the hazardous material - Answer-primary For a Combustible placard used to display an identification number, the entire background below the white background for the ID number must be _______________ during transportation by _______________. - Answer-white, and rail, The identification number 1203 is not required to be displayed on a cargo tank containing only this material, if the cargo tank is marked with the name of this material on each side and rear. What is the name of this material? _______________ - Answer-Gasoline