home improvement EXAM with 100% correct answers already graded A+ 2024

you should always wear eyeprotection you should never operate the saw without ______ even in you think they are in your way guards for your safety, remove chips, small pieces, etc. from the tabletop with the power __________ operating make sure that the _________ is properly secured so it will not rotate during operation turnbase avoid cutting nails. inspect for and remove all nails form the work piece ______ operation before be sure the ______ does not contact the turn base in the lowest position blade ______ perform any freehand operations do not keep _____ out of path of saw blade hands make sure the blade is ___ contacting the work piece before the switch is turned on not wait until the blade attains full ____ before making the cut speed if you notice anything abnormal, _____ tell the teacher the problem stop oporating shut off power and wait for the saw blade to ____ before servicing or adjusting tool stop material should be well supported in such a way that the ______ will not close and bind the blade during the cut kerf _______ pieces should be clamped to a bench or sawhorse small be careful not to ____ into the sawhorse or any other supporting devices cut adjust the blade to extend no more than ____ beyond the thickness of the material being cut 1/4 check the base and angle adjustments to make sure they are ____ tight always plave the base of the saw on the material, making sure the ______ is not making contact before turning on the switch blade during the cut, stand ______ of the cut line, never reaching under the material being cut to the side keep both hands on the ____ while operating the saw handles always _______ the saw to make adjustments, or to change the blade unplug always use the correct ______ for the job bladee make sure the on/off switch is in the ____ position before plugging in off select the correct ____ for the job, and make sure it is properly mounted bladeee _______ the saw to change blades or make adjustments unglugg place the _____ of the saw firmly on the material being cut, before starting the saw base