FCTC Study Guide Test prep Questions And Answers
FCTC Study Guide Test prep Grooming Standard Essay - ANS Take 10 minutes to read and write about the grooming standards Gears - ANS A gear or cogwheel is a rotating machine part having cut teeth, or cogs, which mesh with another toothed part to transmit torque Gear Train - ANS Two or more gears working in a sequence meshed - ANS If the gears are touching adjacent - ANS near, next to, adjoining If the gears are touching then which way are the adjacent gears roatating? - ANS Move in opposite directions Rack - ANS a non-rotating toothed part, called a When two gears mesh, and one gear is bigger than the other (even though the size of the teeth must match), what occurs - ANS mechanical advantage is produced, with the rotational speeds and the torques of the two gears differing in an inverse relationship. Spur gears - ANS straight-cut gears parallel - ANS Side by side and having the same distance continuously between them:"parallel lines never meet" A belt and pulley system is characterized by - ANS two or more pulleys in common to a belt clockwise - ANS flowing the same direction a clock would flow Counter clockwise - ANS Flowing the opposite direction a clock would flow analogous - ANS comparable flanges - ANS an edge that sticks out used to strengthen an object by holding it in place or attaching it to another object rope and pulley system - ANS is characterized by the use of a single continuous rope to transmit a tension force around one or more pulleys to lift or move a load If the anchor knot is at the load - ANS then the mechanical advantage will be odd (1:1, 3:1, 5:1 etc.) If the anchor knot is at the anchor - ANS then the mechanical advantage will be even (2:1, 4:1, 6:1 etc.). Lever - ANS A lever is a machine consisting of a beam or rigid rod pivoted at a fixed hinge fulcrum - ANS The fixed point around which a lever pivots- Where the force cannot affect the object If A lever amplifies an input force it will what - ANS provide a greater output force input force - ANS the force exerted on a machine output force - ANS the force exerted by a machine
Document information
- Uploaded on
- February 18, 2024
- Number of pages
- 2
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers