WOODSHOP MIDTERM EXAM 2024 WITH 100% CORRECT ANSWERS

Band Saw: Wheel doors must be closed and the __________ properly adjusted before turning on the machine. - correct answer blade Band Saw: Adjust the guard so that it is __________ above the stock to be cut. - correct answer ¼" Band Saw: Allow the saw to reach full __________ before you begin the cut. - correct answer speed Band Saw: The stock must be held __________ on the table. - correct answer flat Band Saw: Feed the __________ only as fast as the machine can make the cut. - correct answer stock Band Saw: Maintain a __________ margin of safety. This means keep you fingers__________ away from the blade at all times. - correct answer 2", 2" Band Saw: Plan saw cuts to avoid backing out of __________ whenever possible. - correct answer curves Band Saw: Make turns carefully and do not cut __________ so small that the blade is twisted. - correct answer radii Band Saw: Stop the machine before backing out of long __________ cuts. - correct answer curved Band Saw: Round stock should not be cut unless mounted securely in a __________ - correct answer clamp Band Saw: If you hear clicking noise, turn off the machine and tell the teacher. This indicates a __________ in the blade. If the blade breaks, shut off the power and move away from the machine - correct answer crack Band Saw: Turn off the machine as soon as you have completed your cut. If the machine has a __________, apply it smoothly. Do not leave the machine until it has stopped running. - correct answer brake Disk and Belt Sander: Be certain the belt or disk is correctly mounted. The belt must track in the __________ of the drums and platen. Do not operate the disk sander if the abrasive paper is loose. - correct answer center Disk and Belt Sander: Check the __________ adjustments to see that they are in the correct position and locked securely in place - correct answer fence Disk and Belt Sander: When ever possible use the table, fence, and other guides to control the __________ of the work whenever possible - correct answer position Disk and Belt Sander: Small or irregular shaped pieces should be held in a hand __________ or a special jig or fixture - correct answer clamp Disk and Belt Sander: When sanding the end grain of narrow pieces on the belt sander, always support the work __________ the table. - correct answer against Disk and Belt Sander: Sand only on the side of the disk sander that is going down toward the table. Move the work __________ this surface so that it will not burn. - correct answer along Disk and Belt Sander: Do not use the Sander to shape projects by sanding off __________ amounts of material. - correct answer large Disk and Belt Sander: When sanding on the disk sander, be sure to move the wood around frequently so that the wood does not __________. - correct answer burn Disk and Belt Sander: Sand only clean, new wood. Do not sand work that has excess glue or finish. These materials can load and foul the __________ - correct answer abrasive Drill Press: Check the speed setting to see that it is correct for your work. Holes over__________ should be bored at the lowest speed. - correct answer ½" Drill Press: Use only an approved bit. __________ with feed screws or those that have excessive length generally should not be used. - correct answer bits Drill Press: Mount the bit securely to the full depth of the __________ and in the center. Remove the key immediately. - correct answer chuck Drill Press: Position the table and __________ the feed stroke so there is no possibility of the bit striking the table - correct answer adjust Drill Press: The work should be placed on a wood pad when the __________ will go all the way through your work.