2024 Ca Smog Check Inspector Training Final Review (Part 2) Questions And Answers Solved 100% Correct!!

What constitutes a failure of the crankcase portion of the visible smoke test? - Only smoke emitted from the crankcase vent hoses (PCV System) during the inspection for visible smoke. How long should the tailpipe and crankcase be observed during the idle portion of the Visible Smoke Test? - 10 Seconds Which vehicles are not subject to a Visible Smoke Test? - All hybrid vehicles How long must smoke linger in order to constitute a Visible Smoke Test failure for a diesel vehicle? - More than three seconds. Diesel vehicles are not subject to __________ or _____________ inspections - tailpipe, LPFET What action should be taken if it is determined that the underhood label does not match the engine? - Determine if either the hood or engine has been changed. If it is determined that a hood has been replaced and the underhood label is missing or incorrect for the vehicle, what action should be taken? - Consult the ECS manual to determine required equipment and timing settings. If it is determined that an engine has been changed and the vehicle is not equipped with a BAR Referee Label, what action should be taken? - Refer the vehicle to the referee for certification. What is the minimum amount a consumer must spend before they become eligible for a Repair Cost Waiver? - $650 The Consumer Assistance Program will pay a maximum of __________ toward the cost of an eligible repair. - $500, minus a $20 deductibleDuring a functional test of the EGR system, the RPM does not change when vacuum is applied. What are some possible causes? - Stuck EGR pintle, plugged EGR passage Prior to restraining the vehicle, what should the technician do? - Center the vehicle on the dyno. If the technician attempts to access the BAR97 EIS to replace internal computer components, the 5-gas bench, or pumps, what will occur? - The BAR 97 EIS will lock out, requiring a service call for repair. It is illegal for technician to access the internal portion of the machine? What is the maximum distance a shop/technician can lengthen or shorten a sample hose for the BAR97 EIS? - The hose cannot be lengthened or shortened. Any modification or damage to the hose will require replacement. Under what condition can an inspector shift a manual transmission out of second gear during an ASM inspection? - If the vehicle cannot maintain the appropriate vehicle speed and RPM. What entry should be made into the BAR97 EIS if the GVWR information for a light duty truck is illegible or missing? - Enter NONE into the EIS. If a part is needed for repair and cannot be found locally, who should the customer contact to find the part? - The Emission Parts Locator Service