NCCER Electrical Level 1 Mod 1 Orientation to the Electrical Trade Study

NCCER Electrical Level 1 Mod 1 Orientation to the Electrical Trade Study The NCCER electrical training program applies DOL standards and is a - four-year program Entry into an apprenticeship program is likely to require a(n) - GATB Form Test The minimum standards for the safe installation of electrical systems can be found in - the National Electrical Code (NEC) OSHA standards for general industry are covered in - 29 CFR, Parts The termination of devices and fixtures is completed during a construction phase known as - trim-out Which of the following is true with regard to commercial electrical work? - fire alarm systems are commonly required. In industrial facilities, the electrical systems are most likely maintained by - on-site maintenance personnel Employers of commercial electricians are generally electrical contractors who work as subcontractors for - general contractors Interior panels in residential wiring are typically installed during - rough-in A residential wiring system typically uses - nonmetallic-sheathed cable Commercial wiring is typically installed in - metal raceways Which of the following would most likely require special knowledge of hazardous locations? - Industrial wiring Tract homes are typically wired by - residential electrician Minimum standards for apprentice training programs are established by - the DOL Which of the following is true with regard to your apprenticeship? - licensing requirements vary from state to state Which of the following is true with regard to tardiness and absenteeism? - if you must be absent, call in early so that your employer can find a replacement If you see a safety violation at your job site, you should - report it to your supervisor The primary mission of OSHA is to - ensure that employers maintain a safe workplace is the federal government agency established to ensure a safe and healthy environment in the workplace. - OHSA Job-related learning acquired while working is known as - On-the-job learning (OJL) The main panelboard enclosure would probably be installed in the _______________ stage. - rough-in The ______________ connects the serving utility to the premises wiring system. - electrical service Devices and fixtures would be installed during ________________. - trim-out An enclosure that houses conduit, boxes, and fittings in an electrical system is called a __________________. - raceway system