Level 1 Module 5 Introduction to the National Electrical Code Questions and Answers(A+ Solution guide)

NEC Chapter 5 contains _____. - information on special occupancy areas NEC Chapter 6 covers ______. - special equipment Which of the following rules contain the words shall or shall not and must be adhered to? - Mandatory rules Which of the following rules identify actions that are allowed but not required and typically cover options or alternative methods? - Permissive rules Which of the following serves as the introduction to the NEC and provides an overview of the book? - NEC Article 90 Organizations that test products for safety are _____. - NRTLs The NEC is published by the _____. - National Fire Protection Association The NEC is divided into _______. - 9 chapters The NEC provides Informative Annexes for _____. - informational materials and examples Two terms from NEC Article 100 that trainees should become familiar with are ____. - labeled and Listed Definitions specific to a single NEC article are located ______. - In the second section of each articleNEC Article 250 contains ____. - requirements for grounding and bonding The first nationally recommended electrical code was published in _____. - 1895 NEC Chapter 7 contains information on _____. - emergency systems What is the primary purpose of a Nationally Recognized Testing Laboratory (NRTL)? - To test new products for their compliance with established standards What is the primary purpose of the NEC? - To safeguard persons and property from electrical hazards The duties of the NFPA include which of the following? - Publishing standards to minimize the possibility of fires Which organization is made up entirely of electrical equipment manufacturers? - NEMA The first edition of the NEC was produced by the _____. - National Conference on Standard Electrical Rules Nationally Recognized Testing Laboratories_____. -Make unannounced inspections at electrical equipment factories