CRJ700 Hydraulic System
How many hydraulic systems are installed in the CRJ-700? - Answer- Three independent hydraulic systems What is the function of the pressurized hydraulic fluid? - Answer- Pressurized fluid powers the primary and secondary flight controls, wheel brakes, nose wheel steering, thrust reversers, and the landing gear extension and retraction. Where is the hydraulic system monitored from the cockpit? - Answer- The primary, status, and hydraulic system synoptic pages. How many hydraulic systems power the primary flight controls? - Answer- Primary flight controls are powered by three hydraulic systems. This redundancy prevents the loss of critical flight controls due to failure of a single hydraulic system. How many hydraulic pumps are installed in each hydraulic system? - Answer- Each hydraulic system has two hydraulic pumps, one for normal power and a second as supplementary power. What are the locations of the hydraulic system servicing panels? - Answer- Servicing of the hydraulic system is accomplished on the ground at the service panels located in the aft equipment bay, below the left and right equipment racks (system 1 &2) and on the right side of the aircraft aft of the wing root (system 3) What is the function of the engine driven hydraulic pump? (EDP) - Answer- The EDP's are provided with hydraulic fluid direct from its respective reservoir through a firewall shutoff valve. Each EDP provides pressurized flow to a pressure manifold for distribution to its user system. How are the engine driven pumps cooled? - Answer- Each EDP uses hydraulic fluid for cooling and some hydraulic fluid is leaked from the pumping section to provide lubrication of moving parts. What is the normal output pressure of the engine driven pump (EDP)? - Answer- The working pressure of the EDP is 3,000psi +/- 200 psi What is the normal output pressure of the ac motor pump (ACMP)? - Answer- The working pressure of the ACMP is 3,000psi +/- 200psi What is the function of the "AUTO" position of the ACMP 1b and 2b switches located on the hydraulic control panel? - Answer- Pumps 1b and 2b will activate automatically in the "AUTO" position when their respective buses are powered and generator is operat
Document information
- Uploaded on
- November 27, 2023
- Number of pages
- 3
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers