Test: Field Tech II - III Conventional
Exam Questions and Answers
Which of these components is used in a passive optical network (PON)? - -
Optical splitters.
-Which should be used to cut the fiberdrop's buffer tube? - -A tube cutter
-What is one reason why broadband cable operators install fiber-optic cable
in stages instead of changing the infrastructure all at once? - -Changing the
infrastructure all at once would cause too many service disruptions.
-When a pre-connectorized fiber is not attached to equipment, what should
be attached to help keep it clean? - -A dust cap
-Simplify and solve the equation: If E = IR then I = ? - -E/R
-(480 x 10 to the power of -5) divided by (60 x 10 to the power of -3) = - -8
x 10 to the power of -2
-7 3/8 divided by 7 1/4 = - -1 1/58
-(20) / (-4) + (-2) x (-10) - (-2) x (7) = - -29
-What should you avoid to prevent stress? - -Excessive caffeine
-It is essential to pay attention to warning signs of stress overload. Poor
attitude is one of the behaviors that may indicate that you are overstressed.
What are the symptoms of poor attitude behavior? - -A significant change in
attitude with a noticeable movement toward negative, hostile, cynical, or
paranoid thoughts
-During which step of the six-step troubleshooting process for a digital TV
(DTV) service problem are quadrature amplitude modulation (QAM) channel
measurements typically taken? - -Diagnosing symptoms.
-When troubleshooting a digital TV (DTV) authorization issue, what can be
verified using the set-top box (STB) diagnostic page? - -STB reception of
authorization message data.
-Which of the following is a multicast control protocol between the cable
modem and the CMTS that works in harmony with the downstream channel
bonding for efficient and extensible support for multicast applications? - -
Source-specific multicast (SSM)
, -Which step in the troubleshooting process requires a discussion with the
customer to gather more detail about the problem? - -Step 1: Identify the
problem.
-Which of the following wire color combinations make up quad station wire?
- -Green, red, black, yellow
-A customer reports a problem of no dial tone (NDT). Upon inspection, the
technician notices that new carpeting has been installed. What should the
technician do next? - -Look for a cable that runs under the carpet; it is likely
that the cable has a short from the carpeting tack strip.
-What uses the 2.4-GHz band and runs at 54 Mbps? - -802.11g
-What is the last step of the basic wireless access point (WAP) setup? - -
Apply security.
-Why are wireless local area networks (WLAN) usually deployed in an access
capacity instead of as the network's core layer? - -WLANs are generally
incapable of meeting the requirements of the network core layer, which
needs to be very fast and stable, able to handle a tremendous amount of
traffic with little difficulty, and must experience no down time.
-Wireless internet service providers (ISP) provide which of one of the
following services? - -Last mile data delivery
-What is a symptom of a high voltage standing wave radio (VSWR) in a radio
transmitter? - -high voltage standing wave radio
-How does an antenna create gain in the received signal? - -The antenna's
shape focuses the received signal into a tighter beam
-A transmitter outputs 100 milliwatts (mW). An antenna cable connects the
transmitter to an amplifier, and the power into the amplifier's input
measures 50 mW. The amplifier increases the signal to the original
transmitter's power level and sends the signal to the antenna. The antenna
receives the signal from the amplifier at 75 mW, and then transmits at 150
mW. What is the intentional radiator's (IR) power level in this radio frequency
(RF) circuit? - -75 mW
-Which of the following is an advantage of 802.11b direct sequence spread
spectrum (DSSS) over 802.11 frequency hopping spread spectrum (FHSS)? -
-**Data throughput
Exam Questions and Answers
Which of these components is used in a passive optical network (PON)? - -
Optical splitters.
-Which should be used to cut the fiberdrop's buffer tube? - -A tube cutter
-What is one reason why broadband cable operators install fiber-optic cable
in stages instead of changing the infrastructure all at once? - -Changing the
infrastructure all at once would cause too many service disruptions.
-When a pre-connectorized fiber is not attached to equipment, what should
be attached to help keep it clean? - -A dust cap
-Simplify and solve the equation: If E = IR then I = ? - -E/R
-(480 x 10 to the power of -5) divided by (60 x 10 to the power of -3) = - -8
x 10 to the power of -2
-7 3/8 divided by 7 1/4 = - -1 1/58
-(20) / (-4) + (-2) x (-10) - (-2) x (7) = - -29
-What should you avoid to prevent stress? - -Excessive caffeine
-It is essential to pay attention to warning signs of stress overload. Poor
attitude is one of the behaviors that may indicate that you are overstressed.
What are the symptoms of poor attitude behavior? - -A significant change in
attitude with a noticeable movement toward negative, hostile, cynical, or
paranoid thoughts
-During which step of the six-step troubleshooting process for a digital TV
(DTV) service problem are quadrature amplitude modulation (QAM) channel
measurements typically taken? - -Diagnosing symptoms.
-When troubleshooting a digital TV (DTV) authorization issue, what can be
verified using the set-top box (STB) diagnostic page? - -STB reception of
authorization message data.
-Which of the following is a multicast control protocol between the cable
modem and the CMTS that works in harmony with the downstream channel
bonding for efficient and extensible support for multicast applications? - -
Source-specific multicast (SSM)
, -Which step in the troubleshooting process requires a discussion with the
customer to gather more detail about the problem? - -Step 1: Identify the
problem.
-Which of the following wire color combinations make up quad station wire?
- -Green, red, black, yellow
-A customer reports a problem of no dial tone (NDT). Upon inspection, the
technician notices that new carpeting has been installed. What should the
technician do next? - -Look for a cable that runs under the carpet; it is likely
that the cable has a short from the carpeting tack strip.
-What uses the 2.4-GHz band and runs at 54 Mbps? - -802.11g
-What is the last step of the basic wireless access point (WAP) setup? - -
Apply security.
-Why are wireless local area networks (WLAN) usually deployed in an access
capacity instead of as the network's core layer? - -WLANs are generally
incapable of meeting the requirements of the network core layer, which
needs to be very fast and stable, able to handle a tremendous amount of
traffic with little difficulty, and must experience no down time.
-Wireless internet service providers (ISP) provide which of one of the
following services? - -Last mile data delivery
-What is a symptom of a high voltage standing wave radio (VSWR) in a radio
transmitter? - -high voltage standing wave radio
-How does an antenna create gain in the received signal? - -The antenna's
shape focuses the received signal into a tighter beam
-A transmitter outputs 100 milliwatts (mW). An antenna cable connects the
transmitter to an amplifier, and the power into the amplifier's input
measures 50 mW. The amplifier increases the signal to the original
transmitter's power level and sends the signal to the antenna. The antenna
receives the signal from the amplifier at 75 mW, and then transmits at 150
mW. What is the intentional radiator's (IR) power level in this radio frequency
(RF) circuit? - -75 mW
-Which of the following is an advantage of 802.11b direct sequence spread
spectrum (DSSS) over 802.11 frequency hopping spread spectrum (FHSS)? -
-**Data throughput
