TERTIARY AND VOCATIONAL EDUCATION COMMISSION
COMMON WRITTEN EXAMINATION
All Rights Reserved
Tertiary and Vocational Education Commission
NVQ Level 05 –Semester I
Diploma in Quantity Surveying (NVQ Level V)
Drawing Practice for Quantity
K72T001M01 Three Hours
Surveying
Information & Communication Technology
Answerall questions.
Question No 01
Annexure 01 has shown a plan of a single storied building with 225 mm thick brick walls &
corrugated asbestos cement sheet roofing on timber frame. The slope of roof is 120& eaves
projection is 900 mm from external walls.
Using appropriate scale draw the following & labelled properly.
1. Floor Plan (25 Marks)
2. Section through X –X (20 Marks)
3. Front Elevation (15 Marks)
4. Design suitable foundation detail (25 Marks)
5. Design light points & fan points & mark it on the floor plan (10 Marks)
Assume reasonable values or any suitable assumptions for any data not given& clearly state
such assumptions.
Question No 02
State the most suitable AutoCAD software toolfor the following functions
a) Erasing a part of an object.
b) Drawing a parallel line with equal length to given line.
c) Taking a source object to another place.
d) Modifying dimensions.
e) Create a mirrored copy of source object.
(05Marks)
COMMON WRITTEN EXAMINATION
All Rights Reserved
Tertiary and Vocational Education Commission
NVQ Level 05 –Semester I
Diploma in Quantity Surveying (NVQ Level V)
Drawing Practice for Quantity
K72T001M01 Three Hours
Surveying
Information & Communication Technology
Answerall questions.
Question No 01
Annexure 01 has shown a plan of a single storied building with 225 mm thick brick walls &
corrugated asbestos cement sheet roofing on timber frame. The slope of roof is 120& eaves
projection is 900 mm from external walls.
Using appropriate scale draw the following & labelled properly.
1. Floor Plan (25 Marks)
2. Section through X –X (20 Marks)
3. Front Elevation (15 Marks)
4. Design suitable foundation detail (25 Marks)
5. Design light points & fan points & mark it on the floor plan (10 Marks)
Assume reasonable values or any suitable assumptions for any data not given& clearly state
such assumptions.
Question No 02
State the most suitable AutoCAD software toolfor the following functions
a) Erasing a part of an object.
b) Drawing a parallel line with equal length to given line.
c) Taking a source object to another place.
d) Modifying dimensions.
e) Create a mirrored copy of source object.
(05Marks)
