Redo Multimeter Test | latest with complete solution

Redo Multimeter Test | latest with complete solution After testing the fuses it was determined that the 0.5 amp fuse was bad. Student A indicates they do NOT have an exact replacement fuse, but a cheaper replacement fuse of similar size is acceptable to use. Student B states the correct replacement fuse is specially designed to protect the user in case of an unexpected high amperage draw. Who is correct? - Student B A student uses a multimeter to measure a resistance of a wire and gets a reading of 7.4 k? What would this value be in ohms ? - 7400 ohms The function buttons on the meter may be used to ______ - Both A and B Using the illustration, with the rotary dial set to test micro-amps which two test lead terminal locations should be used? - Terminals 2 and 3 A student can compare known values to measured values when using the REL function of the multimeter - True Of the following four diagnostic products which is the best suited for making exact voltage measurements when pinpoint testing an electronic circuit. - High impedance digital multi-meter Safety is a concern when using the test instruments. Protect yourself by testing the meters for one of the following before conducting any tests. - Test leads for breaks for damage. Safety is a concern when using the test instruments. You can protect yourself by testing the meters for one of the following before conducting any tests. - Test for good meter fuses Student A states using the Amperage setting on the multi meter you can measure the current flow in a circuit. Student B states that the Frequency setting is used to test for Ohms. Who is correct? - Student A The bar graph on the display enables the user to see __________ more easily. - rapidly changing signals To capture a maximum value automatically during testing, which function button would you press? - REC Using the illustration, with the rotary dial set to measure capacitance which two test leads terminal location should be used? - Terminals 3 and 4 When using the meter in the Frequency setting you are measuring what? - The number of times per second a signal happens Which of the following rotary dial setting would be best for measuring the number of cycles per second. - Hz The meter is set-up and testing mV but an OL reading is displayed to correct this situation. Student A state the REL button should be pressed. Student B state the RANGE button should be pressed. Who is correct? - Student B Which function button sets the display to zero and factors out undesired reading? - REL Two Students are discussing the HOLD function button. Student A states the HOLD button will pause or freeze the screen to capture a reading. Student B states the pressing the HOLD button again will return to the live electrical reading. Who is correct? - Both Student A and Student B What does it mean when a meter has "high-impedance" - Can measure a high voltage Two Students are discussing connecting the meter to measure amperage. Student A states the meter leads should be connected in parallel with the circuit. Student B states he meter leads should be connected in series with the circuit. Who is correct? - Student B Using the illustration, what dial setting would be used to test for milli-amps? - D Using the illustration, with the rotary dial set to test frequency which two test lead terminal locations should be used? - Terminals 3 and 4 Using the illustration, what dial setting would be used to test for continuity? - C Using the illustration: when testing the fuse connect the red test lead terminals into which meter terminals (this is referring to the lead terminal, NOT the probing end). - Terminal 4 Using the illustration, with the rotary dial set to test diodes which two test lead terminal locations