Inspector 1 Test Questions with 100% Correct Solutions| Rated A+

the publication that establishes the fire protection engineering policy and criteria for DoD components is: - UFC 3-600-01 NFPA handbooks provide: - examples and illustrations that help you interpret and enforce the codes a tape measure you take with you on an inspection should be at least - 50 feet you are inspecting an area that's under construction. It's lunch time and all construction workers have stopped work. Since you'll be finished with your inspection of this area before the construction begins again, you'll: - wear a hard hat because you are in a construction area during the closing interview, make sure that the building manager: - understands any interim or corrective actions that should be taken All of the following guidelines for scheduling a fire prevention inspection are true except - select a date and time when the facility is normally closed. A facility folder: - provides a history of previous inspections A fire safety deficiency (FSD) is defined as a condition which reduces fire safety below the acceptable level, including noncompliance with standards, but by itself cannot cause a fire to occur. Given this definition, an example of a fire safety deficiency would be: - an exit light that is burned out a benefit of exchanging information with other base agencies that are concerned with life safety is: - mutual assistance in the inspection of a building can enhance the level of life safety for the general public a fire inspector finds a painted sprinkler head during an inspection of a day care facility. To change the behavior of day care staff, the best course of action is to: - explain that paint can prevent the sprinkler head from properly discharging water Department of Defense (DoD) instruction 6055.06, Fire and Emergency Services Program, establishes - the foundation for fire prevention and education programs you've arrived at a facility on time to conduct an inspection; unfortunately, the building manager cannot join you for another 15 minutes. The most efficient way to handle this situation is to: - use this time to return calls or update your calendar and to do list delay, defer and postpone are all words used to describe - procrastination the purpose of the life safety code is to provide __________ requirements for a reasonable degree of safety to life from fire in buildings and structures - minimum when inspecting a pump room or machine shop, you're likely to need - ear protection After completing a fire inspection, you discover a conflict between the current edition of UFC 3-600-01 and a DoD technical guidance (ETL, ITM). The proper course of action to take is to: - apply the DoD technical guidance a clockwise search pattern: - describes a direction that is often used to work through or around a structure systematically when conducting a fire inspection, upon arrival at the building: - enter through the main entrance and identify yourself and the purpose of your visit closing interviews should be conducted at the end of: - each inspection the main difference between preaction systems and dry pipe systems is that: - the water supply valves for preaction systems open on a signal from a detection device, while the water in a dry pipe system is released when a sprinkler head opens to which NFPA standard would you refer for additional information concerning dry chemical fire suppression system - 17 the type of dry chemical system NOT required to activate automatically is a: - hand hoseline a major advantage of the proprietary alarm system is that: - it provides 24-hour monitoring in a remote supervising station alarm system, the annunciator panel would typically be found in the: - fire station