Michigan ASE Brakes Test Correct 100%

On a vehicle with single piston floating caliper front disc brakes, the brake pads on the left side of the vehicle are almost completely worn while the right side is almost new. Technician A says that too much rotor runout could be the cause. Technician B says that a binding caliper piston could be the cause. Who is right? - Answer Technician B only A customer complains that their vehicle pulls to the right when the brakes are applied. Technician A says a restricted brake line to the left caliper can cause this problem. Technician B says a malfunctioning proportioning valve is probably the cause. Who is right? - Answer Technician A only With foot pressure applied, the brake pedal on a vehicle with vacuum assisted power brakes moves down slightly when the engine is started. Tech A says that this condition can be caused by a leaking power brake booster diaphragm. Tech B says that the cause could be a faulty power brake booster check valve. Who is right? - Answer Neither A or B Technician A says that the tool shown above is used to adjust the brake shoes. Technician B says that the tool shown above is used to determine the inside diameter of the drum. Who is right? - Answer Technician A only The hydraulic system on a vehicle with integral ABS is to be bled. Technician A says that the front brakes can be bled in a conventional manner. Technician B says that both front and rear brakes can only be bled using the pressure from a fully charged accumulator. Who is right? - Answer Technician A only Two technicians are discussing the duo-servo type drum brake design. Technician A says the brake lining on the secondary shoe is usually longer and thicker than the brake lining on the primary shoe. Technician B says the primary shoe is installed toward the rear of the vehicle. Who is right? - Answer Technician A only Technician A says that DOT 5 brake fluid has a lower boiling point than DOT 4. Technician B says that DOT 4 brake fluid is silicone-based and should never be used in an ABS system. Who is right? - Answer Neither A or B Technician A says that a caliper seal installed in the caliper bore is called a stroking seal. Technician B says that when the brake pedal is released, the piston in the caliper moves back in its bore due to the action of the piston seal. Who is right? - Answer Technician B only Technician A says that when rebuilding a caliper with a stroking seal, the condition of the caliper bore surface is critical. Technician B says that when rebuilding a caliper with a fixed seal, the condition of the piston surface is the most important consideration. Who is right? - Answer Both A and B Technician A says that when a rotor is machined, an equal amount of material must always be removed from both sides. Technician B says that the minimum thickness dimension cast into the rotor is the dimension that the rotor can be machined to. Who is right? - Answer Neither A or B