ASE A6 practice test (A+ Guaranteed)
B- Always disconnect the ne the negative battery cable and wrap with tape so contract cannot be made. Follow the specific vehicle's disarming instructions, as some SRS system can retain back up power for an additional period of time. correct answers 2. An air bag system is being serviced. Tech A says to disconnect the yellow SRS connectors at the front of the vehicle. Tech B says to disconnect and isolate the negative battery cable. Who is right? A. Tech A only B. Tech B only C. Both A and B D. Neither A or B correct answers Always disconnect negative battery terminal A- for best results and less corrosion at the solder point, a rosin core flux should be used. correct answers 3. Which of these should be used when soldering electrical wiring connections? A. Rosin Core Flux B. Acid core Flux C. Sulfur Core Flux D. none of the above. D- For maximum protection to the computer controlled system of any electronic circuit, it is best to use at least a 10 megohm impedance digital multimeter. correct answers 4. When testing computer controlled systems, a digital multi-meter should be used with an input impedance of at least: A. 10k ohms B. 100k ohms C. 1 megohm D.10 megohms B- always use an ammeter of a low amperage amp clamp with your DMM to troubleshoot a slow drain in an electrical circuit correct answers 5. When troubleshooting a slow drain on the battery, which of these diagnostic tools should be used? A. Ohmeter B. ammeter C. voltmeter D. Test light B- A galvanometer is an analog type voltmeter. OEMs almost universally recommend the use of a non intrusive conductive capacitive type battery tester. correct answers 6. The condition of a lead-acid battery is being checked. Tech A says to use a galvanometer.. Tech B says to use a capacitive battery tester. A. Tech A only B. Tech B only C. Both A and B D. Neither A or B
Document information
- Uploaded on
- September 3, 2023
- Number of pages
- 14
- Written in
- 2023/2024
- Type
- Exam (elaborations)
- Contains
- Questions & answers