AQA 7552 A Level D&T Product Design Series B - Paper 1 Technical principles
AQA 7552 A Level D&T Product Design Series B - Paper 1 Technical principles Please write clearly, in block capitals Centre number Candidate number Surname Forenames(s) Candidate’s signature A-Level - Design & Technology (Product Design) Date of Exam Time allowed: 2 hours 30 minutes Materials For this paper you must have: • normal writing and drawing instruments • a scientific calculator Instructions • Use black ink or black ball-point pen. Use pencil only for drawing • Fill in the information at the top of this page • Answer all questions • You must answer the questions in the spaces provided. Do not write on blank pages • Do all rough work in this paper. Cross through any work that you do not want to be marked Information • The marks for questions are shown in brackets • The maximum mark for this paper is 120 1. Select the most suitable adhesive from the list below to complete the table in figure 1. [3 marks] You may only use an adhesive once. • Contact adhesive • Epoxy resin • PVA • Solvent cement Figure 1 Materials to be bonded Specific adhesive Plywood sheet to beech veneer HIPS (high impact polystyrene) sheet to acrylic rod Melamine formaldehyde veneer to MDF (medium density fibreboard) board
Document information
- Uploaded on
- May 13, 2023
- Number of pages
- 22
- Written in
- 2022/2023
- Type
- Exam (elaborations)
- Contains
- Questions & answers
