Alaris Pump Introduction quiz module 2023 updated passed

Alaris Pump Introduction quiz module 2023 updated passedHard limits (Hard Guardrails) cannot be overridden - correct answer true To interrupt a power down sequence, a user can quickly press any key (except system on) on the PCU - correct answer true Soft limits (soft guardrails) can be overridden, based on clinical requirements - correct answer true The BD Alaris System PC Unit (PCU) can support a max of: - correct answer Four modules; Five only if Auto ID is the fifth module BD Alaris system is a module system intended for: - correct answer All of the above (adult, pediatric, neonatal care) Patient specific care areas are referred to as Profiles within the BD Alaris PCU. - correct answer True Audio volume can be adjusted to the minimum limit set per the profile by pressing the Audio soft key from the main PCU screen. Once the minimum volume has been reached, the Louder/Softer keys are unavailable and an audio tone is emitted. - correct answer True The BD Alaris System can be used on MORE THAN one patient at a time - correct answer false Which of the following are true regarding IUI connectors: A) Visually inspect the IUI connectors for fractures on black colored plastic B) Inspect IUI connectors for contaminants or visible green or blue deposits C) If fractured IUI connectors or visible blue or green deposits are present, do not use the module D) all of the above - correct answer D To restore a primary infusion (select all that apply): A) Press channel select on the module B) Press restore C) Validate programming information parameters are accurate and appropriate D) Press start - correct answer A, B, C, D The Restore feature saves time by recalling rate and volume parameters previously used on the: A) same module B) Alaris PC unit where it was originally from C) same patient D) All of the above E) none of the above - correct answer D The Tamper Resist switch is located on the back of the PCU and can be used when: A) An infusion is running B) During a delay C) when the Alaris EtCO2 Module is actively running D) All of the above - correct answer D The Inter-Unit Interface (IUI) connector is used to establish power and communications between the PCU and attached modules - correct answer True In order to activate a new data set on the PCU, it must: A) Have been downloaded to the PCU via wireless or cable transfer