NACE CIP 1 CBT EXAM PRACTICE QUESTIONS LATEST UPDATED 2022 RATED A+

Dew point is the temperature at which Correct Answer-condensation occurs. You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining. Your FIRST preferred course of action is to: Correct Answer-Document the problem and advise the Contractor and Owner's representative. If a contractor is using a poorly maintained compressor to supply air for abrasive blast cleaning and conventional airspray, the coating inspector should perform a Correct Answer-blotter test for the presence of oil and water. Upon arrival of coating materials, the inspector should Correct Answer-observe and document the amount of material and batch numbers. Relative humidity is Correct Answer-a measure of the amount of moisture in the air compared to saturation level. Galvanic corrosion occurs on which of the following substrates? Correct Answer-Metal When applying Thermal Spray Coatings the specification is most likely to reference: Correct AnswerSSPC-CS 23.00/AWS C2.23/NACE No. 12 What is the minimum recommended distance away from an edge that an inspector should take a measurement with a dial type magnetic pull off Dry Film Thickness(DFT) gauge? Correct Answer-2.5 cm (1 inch) Polymerization is the process of? Correct Answer-Monomers joining together.