Certified Surgical Technologist SelfAssessment Examination Complete QA Complete Questions and Verified Answers

Surgical Technologist SelfAssessment Examination Complete QA Guide | Detailed Correct Solutions A. management of specimens - answer - Which of the following is considered the MOST important skill for a surgical technologist? A. management of specimens B. management of sponges C. maintaining an orderly setup D. ensuring adequate lighting midline. - answer - The surgical incision that allows for the BEST visualization for a Billroth I procedure is... surgical technologist. - answer - During the postoperative phase, the personnel primarily responsible for transporting soiled instrumentation to decontamination is the... Sylvius into the fourth ventricle. - answer - CSF is formed in the lateral ventricles of a patient and may not properly flow into the third ventricle through the foramen of... C. Place in separate containers and identify. - answer - During an excisional biopsy of sentinel nodes, the surgical technologist should prepare specimens using which of the following methods? A. Place on a Raytec to be handed off to the circulator. B. Separate on Telfa and pass to the circulator. C. Place in separate containers and identify. D. Place in specimen container held by the circulator using a hemostat. 0.9% saline + 1 gm bacitracin and 0.25% Marcaine with epinephrine - answer - A surgical technologist received the following medications onto the sterile field: 0.9% sodium chloride, bacitracin 1 gm, and 0.25% Marcaine with epinephrine. Which of the following is the MOST appropriate way to label these medications? B. laps, silk ties, and hemoclips - answer - A thyroidectomy that was done earlier in the day is being brought back for excessive bleeding from the incision. Which of the following items are needed for this case? A. Monocryl suture and harmonic scalpel B. laps, silk ties, and hemoclips C. Vicryl ties, pledgets, and Alexis D. nylon suture, Raytec, and Geralds pathology - answer - If there is any question related to handling a specific type of specimen, which of the following departments should be consulted? 15 to 25. - answer - The required number of air exchanges per hour in an OR is... The manufacturer's standards for sterilizing the instrument are unknown. - answer - A special-made instrument without a backup falls to the floor during a procedure. Which of the following is the BEST reason to hesitate performing immediate-use sterilization? maintained below the patient's chest level. - answer - When transferring a thoracotomy patient to recovery, the chest drainage system should be... mediastinoscopy - answer - Which of the following procedures requires an incision in the suprasternal notch? surgeon and circulating nurse - answer - When preparing surgical specimens, in addition to the surgical technologist, who else is responsible for accurately labeling the specimen? a choledochotomy (the common bile duct is cut open) - answer - A T-tube drain may be used following... cuticular and subcuticular - answer - When assisting with the closure of a skin incision and operating the skin stapler, the surgical technologist places the staples through which two layers? Bier block.During a craniotomy, which of the following types of bone is entered? - answer - A type of regional anesthesia in which a tourniquet is applied and local anesthetic is administered intravenously is called a flat - answer - During a craniotomy, which of the following types of bone is entered? 0.5 mL (Dose ordered ÷ Dose on hand = Volume to give 50 mg ÷ 100 mg/mL = 0.5 mL) - answer - A physician prescribed 50 milligrams of Demerol. The Demerol is supplied in 100 mg/mL. How many mL of Demerol should be given? Mayfield clamp - answer - Which of the following is MOST likely to be used during a posterior cervical decompression? both legs placed in stirrups simultaneously - answer - Which of the following is the MOST acceptable technique when placing a patient in the lithotomy position?