NCCER Module 6: Introduction to Construction
Drawings 2024-2025 (GRADED A+)100%
The natural contours of the land are often shown on a civil plan. - ANS-True
A roof plan is likely to be found on a(n) _____ plan. - ANS-architectural
A foundation plan is likely to be found on a(n) _____ plan. - ANS-structural
The piping layout of a heating system would be found in a(n) _____ plan. - ANS-HVAC
When the metric system is used, dimensions are written in _____. - ANS-meters,
centimeters, and millimeters
If the scale on a site plan reads SCALE: 1" = 20' 0", then every _____ - ANS-inch on the
drawing represents 20 feet, 0 inches
An engineer's scale is set up in multiples of _____ - ANS-10
Which type of plan shows the layout of the HVAC system? - ANS-Mechanical
Electrical plans can include _____. - ANS-lighting plans
Detailed information about a component that is to be used on a project can be found in
the specifications. - ANS-True
On a drawing, a scale of 1" = 5' is given. A line on the drawing is 4" long. What actual
dimension does this 4" line represent? - ANS-20'
On a drawing, a scale of
12"
= 1' is given. A line on the drawing is 3" long. What actual dimension does this 3" line
represent? - ANS-6'
A line that identifies the location of a specific part of the drawing is a(n) _____. - ANS-
leader
A grid divides the area on a plan into small parts called ____. - ANS-bays
Most construction drawings today are hand-drawn by drafters. - ANS-False
The border is a clear area of about _____ inch(es) around the edge of the drawing. -
ANS-1/2
Drawings 2024-2025 (GRADED A+)100%
The natural contours of the land are often shown on a civil plan. - ANS-True
A roof plan is likely to be found on a(n) _____ plan. - ANS-architectural
A foundation plan is likely to be found on a(n) _____ plan. - ANS-structural
The piping layout of a heating system would be found in a(n) _____ plan. - ANS-HVAC
When the metric system is used, dimensions are written in _____. - ANS-meters,
centimeters, and millimeters
If the scale on a site plan reads SCALE: 1" = 20' 0", then every _____ - ANS-inch on the
drawing represents 20 feet, 0 inches
An engineer's scale is set up in multiples of _____ - ANS-10
Which type of plan shows the layout of the HVAC system? - ANS-Mechanical
Electrical plans can include _____. - ANS-lighting plans
Detailed information about a component that is to be used on a project can be found in
the specifications. - ANS-True
On a drawing, a scale of 1" = 5' is given. A line on the drawing is 4" long. What actual
dimension does this 4" line represent? - ANS-20'
On a drawing, a scale of
12"
= 1' is given. A line on the drawing is 3" long. What actual dimension does this 3" line
represent? - ANS-6'
A line that identifies the location of a specific part of the drawing is a(n) _____. - ANS-
leader
A grid divides the area on a plan into small parts called ____. - ANS-bays
Most construction drawings today are hand-drawn by drafters. - ANS-False
The border is a clear area of about _____ inch(es) around the edge of the drawing. -
ANS-1/2
