UTAH PESTICIDE APPLICATOR ACTUAL EXAM QUESTIONS AND ANSWERS
PRACTICE QUESTIONS WITH SOLUTIONS NEWEST | ALREADY GRADED
A+/NEWEST UPDATE!!!
1. A Utah pesticide applicator is preparing to apply a pesticide that is classified
as a Restricted Use Pesticide to a commercial agricultural site. Before
beginning the application, which combination of actions best demonstrates
compliance with pesticide-use requirements?
A. Verify certification requirements, review the entire pesticide label,
confirm the appropriate application category, and follow all applicable
restrictions
B. Ask the property owner whether the pesticide has previously been used
and then apply the same rate
C. Use the pesticide at a higher concentration if the pest population appears
severe
D. Rely on previous experience with the product instead of reviewing the
current label
Answer: A
2. During a pesticide application, an applicator notices that wind speed has
increased substantially and spray droplets are beginning to move toward a
neighboring property. What should the applicator do before continuing?
A. Increase spray pressure so the application can be completed more
quickly
B. Continue because the pesticide is being applied within the property
boundary
C. Stop or modify the application until conditions allow the pesticide to be
applied without unacceptable drift
D. Add an adjuvant without checking the label to make the spray heavier
Answer: C
3. A pesticide label specifies a maximum application rate for a particular crop.
The applicator believes that using twice the labeled rate will provide better
control of a severe infestation. Which action is appropriate?
pg. 1
, A. Apply the higher rate only during the first treatment
B. Follow the labeled maximum rate and do not exceed it because the label
governs legal pesticide use
C. Double the rate if the property owner gives written permission
D. Use the higher rate when environmental conditions are favorable
Answer: B
4. An applicator is selecting personal protective equipment for a pesticide
application and notices that the label requires chemical-resistant gloves and
additional protective clothing. Which approach is most appropriate?
A. Wear only the equipment that feels comfortable
B. Substitute ordinary work gloves because they provide some protection
C. Wear the PPE specified by the pesticide label and follow all additional
safety requirements
D. Avoid PPE when applying pesticides outdoors
Answer: C
5. A pesticide applicator is determining whether a particular application falls
within the ornamental and turf pest-control category. Which situation most
appropriately fits this category?
A. Treating insects affecting an ornamental tree in a maintained landscape
B. Applying pesticide to seeds at a commercial seed-treatment facility
C. Treating roots inside a municipal sewer system
D. Applying pesticide directly to livestock for parasite control
Answer: A
6. A Utah applicator is asked to control pests in a forest nursery where young
trees are being produced for later planting. Which pesticide certification
category is most directly associated with this work?
A. Structural and health-related pest control
B. Forest pest control
C. Aquatic pest control
D. Seed treatment
Answer: B
pg. 2
, 7. An applicator is treating insects on dairy cattle and also applying pesticide
to areas where the cattle routinely live. Which category most appropriately
covers this type of pesticide work?
A. Agricultural pest control—animal
B. Right-of-way pest control
C. Ornamental and turf pest control
D. Forest pest control
Answer: A
8. A pesticide applicator is treating unwanted vegetation along a public
pipeline right-of-way. Which Utah certification category is specifically
associated with this type of work?
A. Agricultural plant pest control
B. Structural pest control
C. Right-of-way pest control
D. Aquatic pest control
Answer: C
9. An applicator is applying a pesticide to control pests inside a food-
processing facility. Which category most directly addresses pesticide
applications in this type of structure?
A. Forest pest control
B. Structural and health-related pest control
C. Seed-treatment pest control
D. Agricultural animal pest control
Answer: B
10. A pesticide applicator needs to determine whether a product is classified as
a Restricted Use Pesticide before purchasing and using it. Which source
should be checked first?
A. The pesticide product label and applicable regulatory information
B. A coworker's memory of how the product was used several years ago
C. A general internet advertisement for the product
pg. 3
, D. The color and shape of the pesticide container
Answer: A
11. A pesticide applicator is preparing a spray mixture and accidentally spills
concentrated pesticide on the outside of the mixing container. What is the
most appropriate immediate response?
A. Ignore the spill if the amount appears small
B. Wash the pesticide into the nearest drain
C. Follow the product label and spill-response procedures while preventing
exposure and environmental contamination
D. Cover the container with soil and continue mixing
Answer: C
12. A commercial applicator is maintaining application records for pesticide
treatments performed for customers. Why are accurate records important?
A. They replace the need to follow pesticide labels
B. They document pesticide applications and can demonstrate compliance
with applicable requirements
C. They allow an applicator to exceed labeled rates
D. They eliminate the need for applicator certification
Answer: B
13. An applicator is asked to use a pesticide for a pest and site combination that
is not listed on the product label. What should the applicator do?
A. Use the product if the pest is biologically similar to a labeled pest
B. Apply it at half the labeled rate
C. Use it only if the customer signs a waiver
D. Determine whether the proposed use is legally permitted before making
the application and do not make an unauthorized use
Answer: D
14. During calibration of a pesticide sprayer, an applicator discovers that the
equipment is delivering considerably more spray than intended. What
should occur before the pesticide is applied?
A. Increase the pesticide concentration to compensate
pg. 4
PRACTICE QUESTIONS WITH SOLUTIONS NEWEST | ALREADY GRADED
A+/NEWEST UPDATE!!!
1. A Utah pesticide applicator is preparing to apply a pesticide that is classified
as a Restricted Use Pesticide to a commercial agricultural site. Before
beginning the application, which combination of actions best demonstrates
compliance with pesticide-use requirements?
A. Verify certification requirements, review the entire pesticide label,
confirm the appropriate application category, and follow all applicable
restrictions
B. Ask the property owner whether the pesticide has previously been used
and then apply the same rate
C. Use the pesticide at a higher concentration if the pest population appears
severe
D. Rely on previous experience with the product instead of reviewing the
current label
Answer: A
2. During a pesticide application, an applicator notices that wind speed has
increased substantially and spray droplets are beginning to move toward a
neighboring property. What should the applicator do before continuing?
A. Increase spray pressure so the application can be completed more
quickly
B. Continue because the pesticide is being applied within the property
boundary
C. Stop or modify the application until conditions allow the pesticide to be
applied without unacceptable drift
D. Add an adjuvant without checking the label to make the spray heavier
Answer: C
3. A pesticide label specifies a maximum application rate for a particular crop.
The applicator believes that using twice the labeled rate will provide better
control of a severe infestation. Which action is appropriate?
pg. 1
, A. Apply the higher rate only during the first treatment
B. Follow the labeled maximum rate and do not exceed it because the label
governs legal pesticide use
C. Double the rate if the property owner gives written permission
D. Use the higher rate when environmental conditions are favorable
Answer: B
4. An applicator is selecting personal protective equipment for a pesticide
application and notices that the label requires chemical-resistant gloves and
additional protective clothing. Which approach is most appropriate?
A. Wear only the equipment that feels comfortable
B. Substitute ordinary work gloves because they provide some protection
C. Wear the PPE specified by the pesticide label and follow all additional
safety requirements
D. Avoid PPE when applying pesticides outdoors
Answer: C
5. A pesticide applicator is determining whether a particular application falls
within the ornamental and turf pest-control category. Which situation most
appropriately fits this category?
A. Treating insects affecting an ornamental tree in a maintained landscape
B. Applying pesticide to seeds at a commercial seed-treatment facility
C. Treating roots inside a municipal sewer system
D. Applying pesticide directly to livestock for parasite control
Answer: A
6. A Utah applicator is asked to control pests in a forest nursery where young
trees are being produced for later planting. Which pesticide certification
category is most directly associated with this work?
A. Structural and health-related pest control
B. Forest pest control
C. Aquatic pest control
D. Seed treatment
Answer: B
pg. 2
, 7. An applicator is treating insects on dairy cattle and also applying pesticide
to areas where the cattle routinely live. Which category most appropriately
covers this type of pesticide work?
A. Agricultural pest control—animal
B. Right-of-way pest control
C. Ornamental and turf pest control
D. Forest pest control
Answer: A
8. A pesticide applicator is treating unwanted vegetation along a public
pipeline right-of-way. Which Utah certification category is specifically
associated with this type of work?
A. Agricultural plant pest control
B. Structural pest control
C. Right-of-way pest control
D. Aquatic pest control
Answer: C
9. An applicator is applying a pesticide to control pests inside a food-
processing facility. Which category most directly addresses pesticide
applications in this type of structure?
A. Forest pest control
B. Structural and health-related pest control
C. Seed-treatment pest control
D. Agricultural animal pest control
Answer: B
10. A pesticide applicator needs to determine whether a product is classified as
a Restricted Use Pesticide before purchasing and using it. Which source
should be checked first?
A. The pesticide product label and applicable regulatory information
B. A coworker's memory of how the product was used several years ago
C. A general internet advertisement for the product
pg. 3
, D. The color and shape of the pesticide container
Answer: A
11. A pesticide applicator is preparing a spray mixture and accidentally spills
concentrated pesticide on the outside of the mixing container. What is the
most appropriate immediate response?
A. Ignore the spill if the amount appears small
B. Wash the pesticide into the nearest drain
C. Follow the product label and spill-response procedures while preventing
exposure and environmental contamination
D. Cover the container with soil and continue mixing
Answer: C
12. A commercial applicator is maintaining application records for pesticide
treatments performed for customers. Why are accurate records important?
A. They replace the need to follow pesticide labels
B. They document pesticide applications and can demonstrate compliance
with applicable requirements
C. They allow an applicator to exceed labeled rates
D. They eliminate the need for applicator certification
Answer: B
13. An applicator is asked to use a pesticide for a pest and site combination that
is not listed on the product label. What should the applicator do?
A. Use the product if the pest is biologically similar to a labeled pest
B. Apply it at half the labeled rate
C. Use it only if the customer signs a waiver
D. Determine whether the proposed use is legally permitted before making
the application and do not make an unauthorized use
Answer: D
14. During calibration of a pesticide sprayer, an applicator discovers that the
equipment is delivering considerably more spray than intended. What
should occur before the pesticide is applied?
A. Increase the pesticide concentration to compensate
pg. 4
