VIVINT SMART HOME PRO
COLLECTED ITEMS EXAM REVIEW
TESTED QUESTIONS ACCURATE
SOLUTIONS
◍ How would you program a CO3 if mounted on a hallway wall?
Loop 1 Zone 8
Loop 1 Zone 14
Loop 3 Zone 4
Loop 1 Zone 4 Answer:
◍ When installing a DW21 into a metal door frame, with a wooden
door, what should you be sure to use?
Metal Drill bit
A DW11 should be used on all metal door frames
3/4" insulated magnet
Eye goggles Answer:
◍ True Answer: T or F: Panic Pendants are programmed as an audible
alarm
◍ T or F: The Firefighter may be installed next to a stand-alone
battery-powered smoke detector Answer:
, ◍ Which of the following zone/sensor types are correct when
programming an SMKT3?
Type 9 - Freeze Detect
Type 7 - Freeze Detect
Type 9 - Heat detect
Type 6 - heat detect
type 1 - heat detect
type 8 - freeze detect
type 5 - smoke detect
type 7 - smoke detect
type 9 - smoke detect Answer:
◍ When installing a DW21 where is the approved location for the
sensor?
Anywhere in the door
between 6"(15 cm) and 2' (61 cm) from floor
Below 6" from the floor
Top of the door Answer:
◍ T or F: When performing a full system test, you may bypass any
open doors or windows Answer:
◍ T or F: When installing a translator, you must program all of the
existing sensors as new equipment on the panel Answer:
COLLECTED ITEMS EXAM REVIEW
TESTED QUESTIONS ACCURATE
SOLUTIONS
◍ How would you program a CO3 if mounted on a hallway wall?
Loop 1 Zone 8
Loop 1 Zone 14
Loop 3 Zone 4
Loop 1 Zone 4 Answer:
◍ When installing a DW21 into a metal door frame, with a wooden
door, what should you be sure to use?
Metal Drill bit
A DW11 should be used on all metal door frames
3/4" insulated magnet
Eye goggles Answer:
◍ True Answer: T or F: Panic Pendants are programmed as an audible
alarm
◍ T or F: The Firefighter may be installed next to a stand-alone
battery-powered smoke detector Answer:
, ◍ Which of the following zone/sensor types are correct when
programming an SMKT3?
Type 9 - Freeze Detect
Type 7 - Freeze Detect
Type 9 - Heat detect
Type 6 - heat detect
type 1 - heat detect
type 8 - freeze detect
type 5 - smoke detect
type 7 - smoke detect
type 9 - smoke detect Answer:
◍ When installing a DW21 where is the approved location for the
sensor?
Anywhere in the door
between 6"(15 cm) and 2' (61 cm) from floor
Below 6" from the floor
Top of the door Answer:
◍ T or F: When performing a full system test, you may bypass any
open doors or windows Answer:
◍ T or F: When installing a translator, you must program all of the
existing sensors as new equipment on the panel Answer:
