• Wrong document? Swap it for free
  • Written by students who passed
  • Immediately available after payment
  • Read online or as PDF
Sell
Where do you study
Your language
Document preview thumbnail
Preview 4 out of 35 pages
Exam (elaborations)

Arizona Az Cr12 Elevators Complete Study Guide.pdf

Document preview thumbnail
Preview 4 out of 35 pages

Comprehensive study guide covering Arizona CR-12 elevator contractor requirements, elevator and escalator systems, installation and maintenance principles, safety procedures, applicable codes and standards, equipment components, and contractor licensing requirements.

Content preview

ARIZONA AZ CR12 ELEVATORS COMPLETE
STUDY GUIDE

◉ A MOV (Metal Oxide Varistor) burns out. You replace it, but cannot
read voltage or resistance. What should you do? Answer: Replace it
with a larger MOV


◉ On a Ward-Leonard circuit the break is set, but the motor is trying
to slip through the break. What is the issue? Answer: Suicide Circuit


◉ You have an old DC motor and are adding an SCR drive, what do
you do to the interpoles? Answer: Leave the interpoles alone. When
adding a SCR drive to the generator, the series loop is removed, as
are the 3 resistors. Everything else remains the same


◉ A hydro runs up with no load, but will not run with a full load.
What is the issue? Answer: The relief valve is set too low


◉ Runby for a 1:1 hits the CWT buffer 4" below the top landing. CWT
runby should be set at 18". How much should the ropes be
shortened? Answer: 22"

,◉ You need to work on a freight door retiring cam, you LOTO the
main line but there is still power on the cam. What circuit is still hot?
Answer: Door Operator Disconnect/ Main Line Disconnect


◉ The contractor requests that the vertical center of a Rack and
Pinion hoist be moved. How do you do this? Answer: Adjust Tie
Downs and Wall Ties


◉ Working pressure on a Hydro is 400psi. What is the maximum
relief valve setting? Answer: 400psi x 150%= 600psi


◉ What must be installed on a false car before operation? Answer:
Spring Loaded Safeties.


◉ There is slight arcing between the brush and commutator. What
action must be taken? Answer: None.
Heavy arcing=Light brush pressure. Heavy bush
pressure=mechanical wear


◉ If rigging gear is roped 3:1 and a BEAM CLAMP is used to lift a
6,000lb load. What is the beam capacity? Answer: 18,000lbs. Beam
capacity is cut in half with use of clamp, when rigging all blocks,
rope, and clamps will be Equal to the lowest load rating

,◉ How much resistance is measured over a normally closed switch?
Answer: 1.2ohms. should be zero, but will never be that low


◉ A car traveling in the hoistway always stops at the same spot and
blows a fuse. What causes this? Answer: Traveling cable has a
cut/exposed wire or a short


◉ How is a class 1 yearly buffer test preformed? Answer: Car at
bottom landing and on inspection, jump out direction and final
limits. With pit clear, run down to compress buffers, buffers should
fully extend within 90 seconds.
5yr: Full load Full speed
CWT: Full speed Empty


◉ How many strain supports are required on a 350ft raceway?
Answer: 4. 1 every 100ft


◉ How is stainless steel drilled out? Answer: Slow speed and
constant pressure


◉ What is the required amount of retainer clips for wedge shackles
and what is the spacing? Answer: Minimum 2 clips. 1st at a
maximum 4x the diameter of the rope
2nd at a maximum 8x the diameter above the 1st clip

, ◉ A 300ohm resistor burns out, but you don't have another one.
How can you make one? Answer: 2 600ohm resistors in parallel is
300ohms. Resistance is half of highest resistor in parallel circuit.
3 225ohm resistors in parallel is 75ohms.


◉ When cutting laminated panels, which direction should the finish
side face? Answer: Finish side facing the cutting edge of the tool.
Blade will burr the backside


◉ How do you cut a finished floor? Answer: Cutting blade away from
finished side


◉ A 480vac stepdown 240vac transformer is connected to a 3 phase
rectifier, what is the output voltage? Answer: 320vac
3 phase full wave = 1.33x output voltage


◉ A car is loaded with 125% and sinks, why? Answer: Slipping
through the break


◉ If you find a broken or missing barricade what should you do?
Answer: Write up a formal inspection request

Document information

Uploaded on
September 22, 2026
Number of pages
35
Written in
2026/2027
Type
Exam (elaborations)
Contains
Questions & answers
$13.99

Wrong document? Swap it for free Within 14 days of purchase and before downloading, you can choose a different document. You can simply spend the amount again.
Written by students who passed
Immediately available after payment
Read online or as PDF

Sold
5
Followers
0
Items
3249
Last sold
4 days ago



Why students choose Stuvia

Created by fellow students, verified by reviews

Quality you can trust: written by students who passed their tests and reviewed by others who've used these notes.

Didn't get what you expected? Choose another document

No worries! You can instantly pick a different document that better fits what you're looking for.

Pay as you like, start learning right away

No subscription, no commitments. Pay the way you're used to via credit card and download your PDF document instantly.

Student with book image

“Bought, downloaded, and aced it. It really can be that simple.”

Alisha Student

Working on your references?

Create accurate citations in APA, MLA and Harvard with our free citation generator.

Working on your references?

Frequently asked questions