NCCCO CORE ACTUAL EXAM WITH
CORRECT ACTUAL QUESTIONS MERGED
WITH CORRECT COMPLETE SOLUTIONS ||
ALREADY GRADED A+ || 2026-2027 LATEST
UPDATE!!!
According to OSHA 1926 subpart cc, what is not allowed inside the fall
zone? - ANSWER-Qualified evaluator
According to OSHA, how often must rigging equipment be inspected? -
ANSWER-Prior to use
The load radius is the distance from the center of rotation to the
centerline of the vertical hoist line(s) with - ANSWER-The suspended
load
All of the following can cause a two-block condition except - ANSWER-
Raising the boom
According to OSHA 1926 subpart cc, where must electrocution hazard
warnings be posted? - ANSWER-In operators cab and on outside of
crane
, What may be required while traveling a crane without a load on a job
site under or near power lines? - ANSWER-A dedicated spotter
According to OSHA 1926 subpart cc, the total load of a personnel
platform must not exceed what percent of the crane's rated capacity?
- ANSWER-50%
According to ASME B30.5, what is the first action to be performed if
the crane loses power? - ANSWER-Set all brakes and locking devices
What is the minimum clearance for cranes traveling with no load near
an energized 40kv electrical line? - ANSWER-6 feet
If outriggers are set at positions that do not correspond to
load/capacity charts, the manufacturer shall be consulted. Who must
be consulted if the required information is not available from the
manufacturer? - ANSWER-Qualified person
When should regular lay running rope be replaced? - ANSWER-When
it has 3 broken wires in one strand in one lay
Who is responsible to know and follow the manufacturer specified
procedures of assembly/disassembly of the crane? - ANSWER-A/D
director
What is the maximum amount of weight that can be imposed on one
outrigger when lifting over a corner? - ANSWER-100% of the crane and
the load
According to OSHA 1926 subpart cc, who has the responsibility of
ensuring that the area needed to support the crane has been prepared
adequately before crane operations begin? - ANSWER-Crane operator
CORRECT ACTUAL QUESTIONS MERGED
WITH CORRECT COMPLETE SOLUTIONS ||
ALREADY GRADED A+ || 2026-2027 LATEST
UPDATE!!!
According to OSHA 1926 subpart cc, what is not allowed inside the fall
zone? - ANSWER-Qualified evaluator
According to OSHA, how often must rigging equipment be inspected? -
ANSWER-Prior to use
The load radius is the distance from the center of rotation to the
centerline of the vertical hoist line(s) with - ANSWER-The suspended
load
All of the following can cause a two-block condition except - ANSWER-
Raising the boom
According to OSHA 1926 subpart cc, where must electrocution hazard
warnings be posted? - ANSWER-In operators cab and on outside of
crane
, What may be required while traveling a crane without a load on a job
site under or near power lines? - ANSWER-A dedicated spotter
According to OSHA 1926 subpart cc, the total load of a personnel
platform must not exceed what percent of the crane's rated capacity?
- ANSWER-50%
According to ASME B30.5, what is the first action to be performed if
the crane loses power? - ANSWER-Set all brakes and locking devices
What is the minimum clearance for cranes traveling with no load near
an energized 40kv electrical line? - ANSWER-6 feet
If outriggers are set at positions that do not correspond to
load/capacity charts, the manufacturer shall be consulted. Who must
be consulted if the required information is not available from the
manufacturer? - ANSWER-Qualified person
When should regular lay running rope be replaced? - ANSWER-When
it has 3 broken wires in one strand in one lay
Who is responsible to know and follow the manufacturer specified
procedures of assembly/disassembly of the crane? - ANSWER-A/D
director
What is the maximum amount of weight that can be imposed on one
outrigger when lifting over a corner? - ANSWER-100% of the crane and
the load
According to OSHA 1926 subpart cc, who has the responsibility of
ensuring that the area needed to support the crane has been prepared
adequately before crane operations begin? - ANSWER-Crane operator
