1
A320 EXAM QUIZZES 2026-27 LATEST VERSION,
FREE INSTANT DOWNLOAD PDF!!
1. Which lights go off when the gear is retracted
A. Nose and Turn Off
B. Turn Off and Wing
C. Nose and Land
D. Logo and Land
2. Which colour code is correct for push button switches?
A. AMBER - immediate action : BLUE - temporary operation
B. GREEN - temporary operation : WHITE - abnormal position
C. WHITE - temporary operation : GREEN - normal operation
D. RED - immediate action : 2 DOTS "not used" part of switch
3. "Below the passenger door window is a red CABIN PRESSURE light which ...
A. ... flashes if there is residual cabin pressure."
B. ... is illuminated whenever the cabin pressure is greater than 2.5 mb."
C. ... flashes with residual pressure and slides armed."
D. ... cannot be seen from outside the aircraft."
4. "Set on LO, the actual pack flow may be ...
A. ... HI due to APU bleed supplying."
B. ... NORM due to APU bleed supplying."
C. ... HI due to air conditioning temperature demands."
D. ... NORM or HI due to single ack operation."
5. "The MAN V/S CTL switch is ...
A. ...operative at all times, and it controls the outflow valve."
B. ... operative in the MAN pressurisation mode: - hold up to OPEN the outflow valve."
C. ... operative in the MAN pressurisation mofe: - hold up to OPEN the safety valve."
D. ... inoperative if the DITCHING switch is ON."
,2
6. What is displayed on the COND S.D. if the primary channel of the Zone Controller has
failed?
A. "ALTN MODE"
B. "PACK REG"
C. Double crosses ( XX )
D. "TRIM AIR VALVE FAULT"
7. What are the Fan Air Valve and pre-cooler used for?
A. Initial cooling of air after entering the pack.
B. Cooling H.P. air only.
C. Cooling bleed air in accordance with pack demands.
D. Cooling bleed air to a maximum of 200℃.
8. The Trim Air Valves:
A. Are electrically controlled by the zone controller.
B. Adjusts temperature by adding cold air.
C. Mix fresh air from the packs with recirculated cabin air.
D. Regulate pack flow depending on number of passengers.
9. With the PACK FLOW selector to NORM, what will the actual flow be?
A. LO or NORM or HI.
B. Always NORM.
C. NORM or HI.
D. NORM or LO.
10. The Avionics Vent System has two "conditions" - GROUND and FLIGHT. When does the
transition from GROUND to FLIGHT occur?
A. After second engine start.
B. At lift-off.
C. At 100 kts. on the take-off roll.
D. When the thrust is set for take-off.
,3
11. Regarding the A/THR indications on the FMA, which is true?
A. ATHR in blue - [ ARMED (actual thrust = TLA) ]
B. ATHR in white - [ ARMED (actual thrust = TLA) ]
C. ATHR in blue - [ ACTIVE (actual thrust is limited by TLA) ]
D. ATHR in white - [ ACTIVE (actual thrust is always less than TLA) ]
12. When can both Autopilots be engaged at the same time?
A. After the APPROACH PHASE is activated on the MCDU.
B. After APPR is armed on the FCU.
C. After LOC capture.
D. After G/S capture.
13. The APU has been switched off,
it has not stopped . Why is this?
A. The APU Fuel Pump continuing to run.
B. The Air Intake Flap failing to close.
C. A cooling period, which occurs on all APU shutdowns.
D. A cooling period (following use of APU Bleed).
14. "The APU may be started ...
A. ... at or below 35,000 feet only."
B. ... at or below 25,000 feet only."
C. ... at or below 300 knots only."
D. ...throughout the normal flight envelope."
15. What happens when the APU MASTER switch is selected to on?
A. The APU Intake Flap opens and the starter motor engages immediately
B
The APU Intake Flap opens and the starter motor engages when the flap is fully open.
.
C. The APU Fuel Pump will operate.
, 4
D. The APU Intake Flap opens.
16. What does the AVAIL light on the START switch indicate?
A. APU starter disengagement.
B. APU electrical power can be used.
C. N speed greater than 75%
D. ECB power-up check is satisfactory.
17. When does the APU starter engage?
A. When the FLAP is fully open and the start switch is pressed on.
B. When the Oil Pressure reaches 7 p.s.i.
C. When the MASTER SW is pressed on.
D. When the START SW is pressed on.
18. On the overhead, when should AUDIO SWITCHING be selected to CAPT 3?
A. The Captain is using RMP tuning of the NAVAIDS.
B. The Captain's ACP has failed.
C. The Captain's loudspeaker has failed.
D. Both RMPs have failed.
19. For the ACP, which is true?
A. The PA TRANSMISSION key operates like other transmission keys.
B. The ON VOICE key enables audio to be heard on the loudspeakers.
C. The RESET key transfers associated ACP (1 or 2) operation to ACP3
D. The RESET key cancels all CALL lights.
20. On the ACP, what does an amber light on a Transmission Key indicate?
A. Failure of the associated transmitter.
A320 EXAM QUIZZES 2026-27 LATEST VERSION,
FREE INSTANT DOWNLOAD PDF!!
1. Which lights go off when the gear is retracted
A. Nose and Turn Off
B. Turn Off and Wing
C. Nose and Land
D. Logo and Land
2. Which colour code is correct for push button switches?
A. AMBER - immediate action : BLUE - temporary operation
B. GREEN - temporary operation : WHITE - abnormal position
C. WHITE - temporary operation : GREEN - normal operation
D. RED - immediate action : 2 DOTS "not used" part of switch
3. "Below the passenger door window is a red CABIN PRESSURE light which ...
A. ... flashes if there is residual cabin pressure."
B. ... is illuminated whenever the cabin pressure is greater than 2.5 mb."
C. ... flashes with residual pressure and slides armed."
D. ... cannot be seen from outside the aircraft."
4. "Set on LO, the actual pack flow may be ...
A. ... HI due to APU bleed supplying."
B. ... NORM due to APU bleed supplying."
C. ... HI due to air conditioning temperature demands."
D. ... NORM or HI due to single ack operation."
5. "The MAN V/S CTL switch is ...
A. ...operative at all times, and it controls the outflow valve."
B. ... operative in the MAN pressurisation mode: - hold up to OPEN the outflow valve."
C. ... operative in the MAN pressurisation mofe: - hold up to OPEN the safety valve."
D. ... inoperative if the DITCHING switch is ON."
,2
6. What is displayed on the COND S.D. if the primary channel of the Zone Controller has
failed?
A. "ALTN MODE"
B. "PACK REG"
C. Double crosses ( XX )
D. "TRIM AIR VALVE FAULT"
7. What are the Fan Air Valve and pre-cooler used for?
A. Initial cooling of air after entering the pack.
B. Cooling H.P. air only.
C. Cooling bleed air in accordance with pack demands.
D. Cooling bleed air to a maximum of 200℃.
8. The Trim Air Valves:
A. Are electrically controlled by the zone controller.
B. Adjusts temperature by adding cold air.
C. Mix fresh air from the packs with recirculated cabin air.
D. Regulate pack flow depending on number of passengers.
9. With the PACK FLOW selector to NORM, what will the actual flow be?
A. LO or NORM or HI.
B. Always NORM.
C. NORM or HI.
D. NORM or LO.
10. The Avionics Vent System has two "conditions" - GROUND and FLIGHT. When does the
transition from GROUND to FLIGHT occur?
A. After second engine start.
B. At lift-off.
C. At 100 kts. on the take-off roll.
D. When the thrust is set for take-off.
,3
11. Regarding the A/THR indications on the FMA, which is true?
A. ATHR in blue - [ ARMED (actual thrust = TLA) ]
B. ATHR in white - [ ARMED (actual thrust = TLA) ]
C. ATHR in blue - [ ACTIVE (actual thrust is limited by TLA) ]
D. ATHR in white - [ ACTIVE (actual thrust is always less than TLA) ]
12. When can both Autopilots be engaged at the same time?
A. After the APPROACH PHASE is activated on the MCDU.
B. After APPR is armed on the FCU.
C. After LOC capture.
D. After G/S capture.
13. The APU has been switched off,
it has not stopped . Why is this?
A. The APU Fuel Pump continuing to run.
B. The Air Intake Flap failing to close.
C. A cooling period, which occurs on all APU shutdowns.
D. A cooling period (following use of APU Bleed).
14. "The APU may be started ...
A. ... at or below 35,000 feet only."
B. ... at or below 25,000 feet only."
C. ... at or below 300 knots only."
D. ...throughout the normal flight envelope."
15. What happens when the APU MASTER switch is selected to on?
A. The APU Intake Flap opens and the starter motor engages immediately
B
The APU Intake Flap opens and the starter motor engages when the flap is fully open.
.
C. The APU Fuel Pump will operate.
, 4
D. The APU Intake Flap opens.
16. What does the AVAIL light on the START switch indicate?
A. APU starter disengagement.
B. APU electrical power can be used.
C. N speed greater than 75%
D. ECB power-up check is satisfactory.
17. When does the APU starter engage?
A. When the FLAP is fully open and the start switch is pressed on.
B. When the Oil Pressure reaches 7 p.s.i.
C. When the MASTER SW is pressed on.
D. When the START SW is pressed on.
18. On the overhead, when should AUDIO SWITCHING be selected to CAPT 3?
A. The Captain is using RMP tuning of the NAVAIDS.
B. The Captain's ACP has failed.
C. The Captain's loudspeaker has failed.
D. Both RMPs have failed.
19. For the ACP, which is true?
A. The PA TRANSMISSION key operates like other transmission keys.
B. The ON VOICE key enables audio to be heard on the loudspeakers.
C. The RESET key transfers associated ACP (1 or 2) operation to ACP3
D. The RESET key cancels all CALL lights.
20. On the ACP, what does an amber light on a Transmission Key indicate?
A. Failure of the associated transmitter.
