ADVANCE RIGGER TEST COMPLETE COURSE
REVIEW GUIDE
◉ The angle factor for 45 degrees is 1.414.
What is the force applied to each leg of a two-leg sling at 45 degrees
lifting a load of 2000 lbs?
Answer: 2000 lb
◉ Boom length on a lattice boom is measured from where?
Answer: center of boom foot pins to center of boom point sheaves
◉ what is the maximum percent of the rated capacity of a crane that
can be used to lift personel?
Answer: 50%
◉ what type of hardware is preferred for angular lifting?
Answer: swivel hoist ring
◉ which of the following MUST be removed from personel platform
before lifting employees?
Answer: test weight
, ◉ when a loads center of gravity is out of balance, what may the
rigging supervisor require?
Answer: an adjustable equalizer beam
◉ ASME. Standard B30.9 makes which requirement about slings?
Answer: slings must be inspected daily before use
◉ which of the following tag lines materials has the BEST non-
conductive properties?
Answer: polyprophylene
◉ when two or more cranes are used to lift a load, who is ultimately
responsible for the operation?
Answer: one designated person
◉ before a spreader bar or beam can be used, what test MUST have
taken place?
Answer: proof tested
◉ when using an equalizer beam on a two-crane lift, the load radius
of each crane is measured from the center line of rotation of each
crane to which of the following?
Answer: center of gravity of the load
REVIEW GUIDE
◉ The angle factor for 45 degrees is 1.414.
What is the force applied to each leg of a two-leg sling at 45 degrees
lifting a load of 2000 lbs?
Answer: 2000 lb
◉ Boom length on a lattice boom is measured from where?
Answer: center of boom foot pins to center of boom point sheaves
◉ what is the maximum percent of the rated capacity of a crane that
can be used to lift personel?
Answer: 50%
◉ what type of hardware is preferred for angular lifting?
Answer: swivel hoist ring
◉ which of the following MUST be removed from personel platform
before lifting employees?
Answer: test weight
, ◉ when a loads center of gravity is out of balance, what may the
rigging supervisor require?
Answer: an adjustable equalizer beam
◉ ASME. Standard B30.9 makes which requirement about slings?
Answer: slings must be inspected daily before use
◉ which of the following tag lines materials has the BEST non-
conductive properties?
Answer: polyprophylene
◉ when two or more cranes are used to lift a load, who is ultimately
responsible for the operation?
Answer: one designated person
◉ before a spreader bar or beam can be used, what test MUST have
taken place?
Answer: proof tested
◉ when using an equalizer beam on a two-crane lift, the load radius
of each crane is measured from the center line of rotation of each
crane to which of the following?
Answer: center of gravity of the load
