NCCCO LATTICE BOOM GENERAL KNOWLEDGE
WITH CORRECT QUESTIONS WITH CORRECTRY
ANALYZED ANSWERS (ACTUAL EXAM) ALREADY
GRADED A+
Play your way to mastery with fun games
Match Blocks Charms NEW
Practice questions for this set
Learn 1 /7 Study with Learn
18 times
Choose an answer
The lattice boom is designed to take winds of up to 20 mph. from the side plus a full
1
rated load, plus a direct side load equal to what percent of the rated load?
, Load- hoisting sheaves shall have a pitch diameter not less than _______ the nominal
2
diameter of the rope used.
During disassembly of a long boom, the pendant lines are connected at the maximum
3 cantilever point and the boom is slightly lifted off the ground, which boom connection
pins are to be removed next?
If the manufacture of a particular crane does not specifically permit pick and carry
4
operations what procedure must be followed during this operation?
Don't know?
Terms in this set (58)
The lattice boom is designed to take 2%
winds of up to 20 mph. from the side
plus a full rated load, plus a direct
side load equal to what percent of
the rated load?
The part of the load chart governed A. 75%
by stability is based on what
percentage of capacity while a
crawler crane is working over the side
quadrant?
The most unstable working quadrant Side
for a crawler crane is the;
WITH CORRECT QUESTIONS WITH CORRECTRY
ANALYZED ANSWERS (ACTUAL EXAM) ALREADY
GRADED A+
Play your way to mastery with fun games
Match Blocks Charms NEW
Practice questions for this set
Learn 1 /7 Study with Learn
18 times
Choose an answer
The lattice boom is designed to take winds of up to 20 mph. from the side plus a full
1
rated load, plus a direct side load equal to what percent of the rated load?
, Load- hoisting sheaves shall have a pitch diameter not less than _______ the nominal
2
diameter of the rope used.
During disassembly of a long boom, the pendant lines are connected at the maximum
3 cantilever point and the boom is slightly lifted off the ground, which boom connection
pins are to be removed next?
If the manufacture of a particular crane does not specifically permit pick and carry
4
operations what procedure must be followed during this operation?
Don't know?
Terms in this set (58)
The lattice boom is designed to take 2%
winds of up to 20 mph. from the side
plus a full rated load, plus a direct
side load equal to what percent of
the rated load?
The part of the load chart governed A. 75%
by stability is based on what
percentage of capacity while a
crawler crane is working over the side
quadrant?
The most unstable working quadrant Side
for a crawler crane is the;
