CFESA ELECTRICAL PRACTICE TEST
1. A capacitor start motor should be used in what applications?: used for heavy-duty
applications requiring high starting torque. refrigerator compressors, pumps, and conveyors.
2. You have 120 V super warmer that is not heating. Your meter reads 120 V
from each side of the element to the ground. The voltage across the element
reads 0 V. What is the issue?: Open neutral after the element
3. If you check each side of an element terminal to ground and read 120 V does
that mean the element has voltage to it?: No measure voltage across the load, not from each
terminal to ground
4. A ground fault breaker is considered more reliable than a ground fault
receptacle. T or F?: True
5. A thermostat has a differential of 5°F. This means:: the temperature needs to drop 5
degrees below the set point before the heating system turns on
6. Wall receptacles failed due to:: loose wires, overloaded circuits (tripped breakers), damaged
internal components, wear and tear from frequent use, exposure to moisture, or physical damage which can lead to
poor connections or short circuits.
7. It is still possible to get shocked by touching the casing of a piece of equip-
ment if it is properly grounded. T or F?: False
8. Before working on electrical equipment with the power on:: Proper PPE must be
worn, example of this is linesman's gloves
9. Add 240 V range connected to a 208 V power supply will:: it will likely operate with
reduced power and potentially experience issues like longer cooking times, decreased heating eflciency, and could
potentially be damaged over time
10. AC power has a negative and a positive line. T or F?: False, it has a hot and a neutral
11. Which formula should you use to determine the power consumed by a 15
ohm heater element with 8 A of current flowing through it?: P= I x I x R
12. A hot line in an AC power supply contains 120 V. T or F?: False, 120 volts is the
ditterence in potential between the hot line and neutral.
13. On the ohms law wheel what does P stand for?: Power
14. Line voltage is the potential difference between:: any two lines and phases in a
, three-phase electrical system; essentially, the voltage measured between two live wires in a power circuit.
15. Prefix Milli means:: 1/1000
1. A capacitor start motor should be used in what applications?: used for heavy-duty
applications requiring high starting torque. refrigerator compressors, pumps, and conveyors.
2. You have 120 V super warmer that is not heating. Your meter reads 120 V
from each side of the element to the ground. The voltage across the element
reads 0 V. What is the issue?: Open neutral after the element
3. If you check each side of an element terminal to ground and read 120 V does
that mean the element has voltage to it?: No measure voltage across the load, not from each
terminal to ground
4. A ground fault breaker is considered more reliable than a ground fault
receptacle. T or F?: True
5. A thermostat has a differential of 5°F. This means:: the temperature needs to drop 5
degrees below the set point before the heating system turns on
6. Wall receptacles failed due to:: loose wires, overloaded circuits (tripped breakers), damaged
internal components, wear and tear from frequent use, exposure to moisture, or physical damage which can lead to
poor connections or short circuits.
7. It is still possible to get shocked by touching the casing of a piece of equip-
ment if it is properly grounded. T or F?: False
8. Before working on electrical equipment with the power on:: Proper PPE must be
worn, example of this is linesman's gloves
9. Add 240 V range connected to a 208 V power supply will:: it will likely operate with
reduced power and potentially experience issues like longer cooking times, decreased heating eflciency, and could
potentially be damaged over time
10. AC power has a negative and a positive line. T or F?: False, it has a hot and a neutral
11. Which formula should you use to determine the power consumed by a 15
ohm heater element with 8 A of current flowing through it?: P= I x I x R
12. A hot line in an AC power supply contains 120 V. T or F?: False, 120 volts is the
ditterence in potential between the hot line and neutral.
13. On the ohms law wheel what does P stand for?: Power
14. Line voltage is the potential difference between:: any two lines and phases in a
, three-phase electrical system; essentially, the voltage measured between two live wires in a power circuit.
15. Prefix Milli means:: 1/1000