TELECOM TOWER TECHNICIAN 1 UPDATED ACTUAL
QUESTIONS AND CORRECT ANSWERS
Question:
1. The basket slings on a gin pole perform what function?
Answer:
Support part of the weight and vertical forces
Question:
2. What is the minimum force that a work positioning system anchorage must be able to withstand?
Answer:
2 times the arresting force or 3,000 lbs
Question:
3. What term identifies a monopole component?
Answer:
Base flange
Question:
4. All antennas are presumed active
Answer:
True
Question:
5. When using bolts or u-bolts with a slotted hole present, what order are the components installed?
Answer:
Flat washer, lock washer, then nut
Question:
6. If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the base
need to be to provide the correct slope?
Answer:
4 ft
Question:
7. For structural loading purposes the basket and bridle slings shall always be attached where?
Answer:
At a panel point around the leg
Question:
8. A hoist operator will respond to a stop signal from whom?
Answer:
Any source
, Question:
9. When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out distance?
Answer:
4 feet
Question:
10. How often shall all gin poles have a documented job inspection?
Answer:
Daily
Question:
11. What do the letters LOTO stand for?
Answer:
Lockout Tagout
Question:
12. What does a tag person do?
Answer:
Applied pressure on the tag rope to controls the load
Question:
13. A capstan hoist is used on job sites for what purpose?
Answer:
To raise and lower loads
Question:
14. When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear what?
Answer:
Gloves
Question:
15. What does a Ground Fault Circuit Interrupter (GFCI) do?
Answer:
Shuts off flow of electricity, senses a short circuit, and prevents electricution
Question:
16. Which of the following is not a component of the gross load?
Answer:
Tag force
Question:
17. What motion indicates retract the boom
Answer:
Both fists in front of your body with your thumbs pointed towards each other
QUESTIONS AND CORRECT ANSWERS
Question:
1. The basket slings on a gin pole perform what function?
Answer:
Support part of the weight and vertical forces
Question:
2. What is the minimum force that a work positioning system anchorage must be able to withstand?
Answer:
2 times the arresting force or 3,000 lbs
Question:
3. What term identifies a monopole component?
Answer:
Base flange
Question:
4. All antennas are presumed active
Answer:
True
Question:
5. When using bolts or u-bolts with a slotted hole present, what order are the components installed?
Answer:
Flat washer, lock washer, then nut
Question:
6. If you have a 16 ft ladder leaning against a building wall, how many feet from the wall does the base
need to be to provide the correct slope?
Answer:
4 ft
Question:
7. For structural loading purposes the basket and bridle slings shall always be attached where?
Answer:
At a panel point around the leg
Question:
8. A hoist operator will respond to a stop signal from whom?
Answer:
Any source
, Question:
9. When calculating a fall distance using a 6 foot energy absorber, what is the maximum pull out distance?
Answer:
4 feet
Question:
10. How often shall all gin poles have a documented job inspection?
Answer:
Daily
Question:
11. What do the letters LOTO stand for?
Answer:
Lockout Tagout
Question:
12. What does a tag person do?
Answer:
Applied pressure on the tag rope to controls the load
Question:
13. A capstan hoist is used on job sites for what purpose?
Answer:
To raise and lower loads
Question:
14. When operating a Capstan Hoist, or tagging the load on the Capstan, it is important to wear what?
Answer:
Gloves
Question:
15. What does a Ground Fault Circuit Interrupter (GFCI) do?
Answer:
Shuts off flow of electricity, senses a short circuit, and prevents electricution
Question:
16. Which of the following is not a component of the gross load?
Answer:
Tag force
Question:
17. What motion indicates retract the boom
Answer:
Both fists in front of your body with your thumbs pointed towards each other
