FLORIDA HOME INSPECTOR EXAM
ULTIMATE PASS KIT 130 QUESTION
ACICP GOLD COAST MASTER PRACTICE
POOL 2026 2027
ACICP Gold Coast Florida Home Inspector Master
Practice Pool
1. During the inspection of a concrete block home in the
Florida Keys, the inspector notes that the structural roof-
to-wall connectors consist of metal hurricane straps.
According to the Florida Building Code (FBC) residential
mitigation standards, what is the minimum required
number of nails that must be fully engaged in each strap to
qualify for a standard "clips" or "wraps" insurance wind
mitigation discount?
A) One nail placed directly through the top center of the
strap into the top plate.
B) At least three approved nails wrapping or
fastening the metal connector to the truss/rafter,
ensuring proper uplift structural path resistance.
C) Two standard smooth-shank roofing staples driven into
the fascia board array layout.
D) Five nails, but only if the home is located more than ten
miles away from the salt-water coast bounds.
Correct Answer: B. Rationale: For Florida wind
mitigation inspections (Form OIR-B1-1802), a hurricane
clip requires a minimum of 3 nails into the truss/rafter to
qualify for the premium credit. Wraps require at least 3
nails as well; smooth-shank staples or fewer nails do not
meet the structural wind uplift resistance threshold.
2. While inspecting a residential swimming pool enclosure
cage at a home in Gold Coast, Palm Beach County, the
, home inspector is evaluating the child safety features
under the Florida Residential Landlord and Tenant Act
and the Jessica Lunsford Act (Florida Statute Chapter
515). They note a self-closing, self-latching pool safety
gate. What is the mandatory regulatory requirement
regarding the directional swing of this gate?
A) The safety gate must swing inward toward the water
surface to make entry faster for swimming supervisors.
B) The gate must swing outward, away from the
pool area, and the latch release mechanism must
be located a minimum of 54 inches above the
ground.
C) The gate can swing in either direction provided it
features a commercial-grade hydraulic door closer
tracking system.
D) The gate must slide horizontally along a solid track
embedded in the concrete pool deck surface.
Correct Answer: B. Rationale: The Florida
Residential Swimming Pool Safety Act (Chapter 515,
Florida Statutes) explicitly mandates that all perimeter
gates access lines must open outward (away from the
pool pool) and be self-closing and self-latching, with the
release handle mounted at least 54 inches high to prevent
toddlers from opening it.
3. A Florida home inspector is evaluating an asphalt shingle
roof system on a home built in 2012 in Broward County.
They observe a slight architectural distortion or lifting
along the lower edges of multiple shingles. Upon closer
evaluation, they identify that the underlayment material
consists of a single layer of standard 15-pound organic felt
paper. What should the inspector state in their report
regarding the underlayment standard under the current
Florida Building Code updates?
A) The underlayment is fully compliant because 15-pound
, felt paper carries a lifetime structural warranty in high-
velocity hurricane zones.
B) The installation does not meet modern FBC
standards for re-roofing, which require a sealed
roof deck system using self-adhering polymer-
modified bitumen tape over joints or a full peel-
and-stick underlayment.
C) Roof underlayment is an optional luxury material that
carries no structural significance during wind mitigation
audits.
D) The underlayment must be entirely removed and
replaced with a layer of thick marine structural plywood
sheets.
Correct Answer: B. Rationale: Modern updates to
the Florida Building Code (Residential) have significantly
tightened roof underlayment mandates to prevent water
intrusion. A "sealed roof deck" (using self-adhering tape
over plywood joints or a full self-adhering peel-and-stick
underlayment membrane) is mandatory during re-
roofing to enhance windstorm resistance.
4. During a home inspection in Fort Lauderdale, the
inspector opens the primary electrical service panel
(breaker box) located on the exterior wall of the house.
They observe a 200-amp main breaker feeding a copper
bus bar. One of the branch circuit breakers is a 20-amp
single-pole breaker wrapped with two separate solid
aluminum conductors entering the terminal lug. How
should this finding be reported?
A) It is fully acceptable because double-wiring terminals
maximizes current throughput.
B) It represents a minor cosmetic blemish that can be
ignored if the insulation color is white.
C) It is a critical safety hazard: aluminum branch
wiring is prone to oxidation and loose
, connections, and "double-tapping" a single
breaker terminal is prohibited unless the breaker
is explicitly rated for two wires.
D) Aluminum wire must always be connected to a
minimum of a fifty-amp double-pole breaker to avoid
voltage spikes.
Correct Answer: C. Rationale: This scenario
presents two distinct electrical faults: "Double-tapping"
(inserting two wires into a terminal lug designed for one)
creates loose connections and arcing. Furthermore,
single-strand aluminum branch circuit wiring (common
in late 1960s to mid-1970s homes) represents a fire
hazard due to thermal expansion/contraction and
oxidation, requiring specialized Al/Cu rated terminal
connections or pig-tailing.
5. A home inspector is examining the crawlspace area
beneath a pier-and-beam coastal home in Naples, Florida.
They notice several structural wood floor joists are in
direct contact with the soil surface. They also identify a
white, powdery, tracking shelter tube running vertically up
the side of a concrete block pier to the floor framing. What
biological wood-destroying organism (WDO) hazard does
this tracking tube indicate?
A) Widespread localized infestation of wood-boring
powderpost beetle larvae.
B) Active subterranean termites utilizing shelter
tubes to maintain moisture levels while migrating
from the soil to eat the wood framing.
C) Superficial mold growth caused by high humidity lines
within the crawlspace floor insulation.
D) Carpenter bee nesting tunnels bored into the structural
subfloor framing layers.
Correct Answer: B. Rationale: Subterranean
termites require continuous access to soil moisture to
ULTIMATE PASS KIT 130 QUESTION
ACICP GOLD COAST MASTER PRACTICE
POOL 2026 2027
ACICP Gold Coast Florida Home Inspector Master
Practice Pool
1. During the inspection of a concrete block home in the
Florida Keys, the inspector notes that the structural roof-
to-wall connectors consist of metal hurricane straps.
According to the Florida Building Code (FBC) residential
mitigation standards, what is the minimum required
number of nails that must be fully engaged in each strap to
qualify for a standard "clips" or "wraps" insurance wind
mitigation discount?
A) One nail placed directly through the top center of the
strap into the top plate.
B) At least three approved nails wrapping or
fastening the metal connector to the truss/rafter,
ensuring proper uplift structural path resistance.
C) Two standard smooth-shank roofing staples driven into
the fascia board array layout.
D) Five nails, but only if the home is located more than ten
miles away from the salt-water coast bounds.
Correct Answer: B. Rationale: For Florida wind
mitigation inspections (Form OIR-B1-1802), a hurricane
clip requires a minimum of 3 nails into the truss/rafter to
qualify for the premium credit. Wraps require at least 3
nails as well; smooth-shank staples or fewer nails do not
meet the structural wind uplift resistance threshold.
2. While inspecting a residential swimming pool enclosure
cage at a home in Gold Coast, Palm Beach County, the
, home inspector is evaluating the child safety features
under the Florida Residential Landlord and Tenant Act
and the Jessica Lunsford Act (Florida Statute Chapter
515). They note a self-closing, self-latching pool safety
gate. What is the mandatory regulatory requirement
regarding the directional swing of this gate?
A) The safety gate must swing inward toward the water
surface to make entry faster for swimming supervisors.
B) The gate must swing outward, away from the
pool area, and the latch release mechanism must
be located a minimum of 54 inches above the
ground.
C) The gate can swing in either direction provided it
features a commercial-grade hydraulic door closer
tracking system.
D) The gate must slide horizontally along a solid track
embedded in the concrete pool deck surface.
Correct Answer: B. Rationale: The Florida
Residential Swimming Pool Safety Act (Chapter 515,
Florida Statutes) explicitly mandates that all perimeter
gates access lines must open outward (away from the
pool pool) and be self-closing and self-latching, with the
release handle mounted at least 54 inches high to prevent
toddlers from opening it.
3. A Florida home inspector is evaluating an asphalt shingle
roof system on a home built in 2012 in Broward County.
They observe a slight architectural distortion or lifting
along the lower edges of multiple shingles. Upon closer
evaluation, they identify that the underlayment material
consists of a single layer of standard 15-pound organic felt
paper. What should the inspector state in their report
regarding the underlayment standard under the current
Florida Building Code updates?
A) The underlayment is fully compliant because 15-pound
, felt paper carries a lifetime structural warranty in high-
velocity hurricane zones.
B) The installation does not meet modern FBC
standards for re-roofing, which require a sealed
roof deck system using self-adhering polymer-
modified bitumen tape over joints or a full peel-
and-stick underlayment.
C) Roof underlayment is an optional luxury material that
carries no structural significance during wind mitigation
audits.
D) The underlayment must be entirely removed and
replaced with a layer of thick marine structural plywood
sheets.
Correct Answer: B. Rationale: Modern updates to
the Florida Building Code (Residential) have significantly
tightened roof underlayment mandates to prevent water
intrusion. A "sealed roof deck" (using self-adhering tape
over plywood joints or a full self-adhering peel-and-stick
underlayment membrane) is mandatory during re-
roofing to enhance windstorm resistance.
4. During a home inspection in Fort Lauderdale, the
inspector opens the primary electrical service panel
(breaker box) located on the exterior wall of the house.
They observe a 200-amp main breaker feeding a copper
bus bar. One of the branch circuit breakers is a 20-amp
single-pole breaker wrapped with two separate solid
aluminum conductors entering the terminal lug. How
should this finding be reported?
A) It is fully acceptable because double-wiring terminals
maximizes current throughput.
B) It represents a minor cosmetic blemish that can be
ignored if the insulation color is white.
C) It is a critical safety hazard: aluminum branch
wiring is prone to oxidation and loose
, connections, and "double-tapping" a single
breaker terminal is prohibited unless the breaker
is explicitly rated for two wires.
D) Aluminum wire must always be connected to a
minimum of a fifty-amp double-pole breaker to avoid
voltage spikes.
Correct Answer: C. Rationale: This scenario
presents two distinct electrical faults: "Double-tapping"
(inserting two wires into a terminal lug designed for one)
creates loose connections and arcing. Furthermore,
single-strand aluminum branch circuit wiring (common
in late 1960s to mid-1970s homes) represents a fire
hazard due to thermal expansion/contraction and
oxidation, requiring specialized Al/Cu rated terminal
connections or pig-tailing.
5. A home inspector is examining the crawlspace area
beneath a pier-and-beam coastal home in Naples, Florida.
They notice several structural wood floor joists are in
direct contact with the soil surface. They also identify a
white, powdery, tracking shelter tube running vertically up
the side of a concrete block pier to the floor framing. What
biological wood-destroying organism (WDO) hazard does
this tracking tube indicate?
A) Widespread localized infestation of wood-boring
powderpost beetle larvae.
B) Active subterranean termites utilizing shelter
tubes to maintain moisture levels while migrating
from the soil to eat the wood framing.
C) Superficial mold growth caused by high humidity lines
within the crawlspace floor insulation.
D) Carpenter bee nesting tunnels bored into the structural
subfloor framing layers.
Correct Answer: B. Rationale: Subterranean
termites require continuous access to soil moisture to
